Table of Contents
Calculate How Much Soil You Need In this example, you need to fill in 3″ of soil to level a space that is 10′ x 15′. Convert the inches you need for soil depth into feet. Multiply the length by the width by the depth of soil needed. Divide the cubic feet by 27 (that’s the number of cubic feet in one cubic yard).
How do I calculate how much dirt I need to level my yard?
Length in feet x Width in feet x Depth in feet (inches divided by 12). Take the total and divide by 27 (the amount of cubic feet in a yard). The final figure will be the estimated amount of cubic yards required.
How much topsoil Do I need to level my lawn?
Rake the topdressing to spread it out evenly. Apply 1/4″-1/2″ of soil mixture on top of the low areas. Only 1/2” of material can be applied at a time so that you don’t smother the grass; With a push-broom (or leveling rake), work the soil mixture into the grass as thoroughly as possible.
How much dirt do I need to grade my house?
Ideally, the ground should drop one inch for every one foot that you move away from the house for the first 5-to-10 feet around your house. While this is not always possible, the ground should never be sloping upwards as you move away from your house foundation.
How much does it take to level a yard?
Cost to level a yard by project. The cost to level a yard is $500 to $5,000 on average, depending on the project size and type, slope, and site conditions. Leveling a small area for a patio or pool costs $500 to $1,000. Leveling an entire backyard to flatten a slope costs $1,000 to $5,000.
How do I calculate how much dirt I need?
To estimate soil volume for any area, all you need is a tape measure. “The basic formula is simple: Length x Width x Height = Volume,” says Michael Dean, co-founder of Pool Research. Then divide the number of cubic feet by 27. So one cubic yard = 27 cubic feet = 1,728 cubic inches.
How much dirt does it take to raise 1 acre of 1 foot?
So, if you dig 1 foot deep over an acre, you get 43,560 cubic feet of dirt. If you dig 5 feet deep, then you have 5 times this amount of dirt. If you dig 5 feet of dirt out of 50 acres, then you have 50 times as much dirt as if you did that over 1 acre.
How many 40lb bags of topsoil are in a yard?
Since 27 cubic ft is a cubic yard, it would take 54 bags to make a yard.
Can I put topsoil over grass and reseed?
Adding soil over grass can be another effective form of repairing a lawn. It is possible to dump new soil over top of what you have, and prepare it for sod or seed. If you are not putting down a thick enough layer of soil to kill everything underneath, you may have to make some other choices.
How do you fix an uneven lawn?
Areas of a lawn can become uneven over time, due to settling, drainage issues, and various natural and unnatural causes. In the least extreme cases, you can solve the problem by topdressing with a thin layer of leveling mix (soil, compost, and sand).
How deep should my topsoil be?
Plants grow best in topsoil rated deep, which is 36 inches, to very deep. They develop strong root systems that provide better stability and support, which is especially important for large shrubs and trees.
How many bags of soil do I need?
Find out How Many Bags of Soil, Mulch, or Compost You Need # Cubic Yards Needed Bag Size .75 Cubic Feet 2 cubic Feet 1 Yard 36 bags 14 bags 3 Yards 108 bags 41 bags 10 Yards 360 bags 135 bags.
How do you level a yard by hand?
How to Level a Yard [8 Steps] STEP 1: Mow Your Lawn. STEP 2: Dethatch Your Lawn [As Needed] STEP 3: Dig up the grass in the sunken area of the lawn. STEP 4: Make Soil Mix: Topsoil, Sand and Compost. STEP 5: Fill Sunken Areas and Holes with Soil Mixture. STEP 6: Even Out the Entire Lawn. STEP 7: Water the Lawn.
How hard is it to grade a yard?
This yard grading project, just like every other project, took a bit of planning. The actual grading of the yard wasn’t difficult at all– except for the mix of 90 degree heat and manual labor. Despite its simplicity, here are some potential items you should address before starting the project.
How much does it cost to even out a lawn?
area ranges from $1,500 to $2,600. Most homeowners pay around $1,800 to regrade a 1,000 sq. ft. yard with a 2-foot slope that needs 5 cubic yards of fill dirt and 10 cubic yards of topsoil added.Cost to Level Yard. Average Cost to Regrade a Yard Average range $1,500-$2,600 Low-end $550 High-end $8,200.
How much area will a ton of dirt cover?
As a general guide, 1 cubic yard of aggregate, sand, or dirt is equivalent to 1.5 tons. Coverage Chart 1″ Depth 324 Sq. Ft. 3″ Depth 108 Sq. Ft. 4″ Depth 81 Sq. Ft. 5″ Depth 67 Sq. Ft.
How many square feet does a yard of dirt cover?
How Much Does A Yard Cover? A cubic yard of material can be spread to cover 100 square feet (10×10 foot area) at 3 inches of depth. It’s a very helpful ratio because when spreading mulch, a depth of 3 inches is considered ideal.
What is a yard of dirt?
For example, if you dig up a flower bed that is 9 feet long, 3 feet wide and 12 inches deep, you will have one cubic yard of dirt. 3 feet equals 1 yard, so 9 feet equals 3 total yards in length. The width of 3 feet equals 1 yard.
