Table of Contents
How Many Footings Will I Need? The standard rule for footings is that for a basic deck, the larger the beam and footing size, the fewer footings you’ll need. If you’re building a simple deck, footings and posts should be placed 8 feet apart on average.
How far apart do footings need to be for a deck?
For most situations, you will want to place footings and posts less than 8′ apart. If you are planning on installing a hot tub or porch on top of your deck, you will usually need more footings and posts to support the additional loads. Decks with a lot of angles may also require additional footings.
How many footings do I need for a freestanding deck?
Quick Attached Deck Footing Chart Size of Deck Beam Size Number of Footings 12′ x 12′ (2) 2×6 3 16′ x 16′ (3) 2×8 3 20′ x 12′ (2) 2×8 3 20′ x 14′ (2) 2×8 3.
How many support posts do I need for a deck?
The larger 12-foot side will have a post spacing of 6 feet at a minimum code requirement. That makes a total of eight posts that need to be installed on this average size deck. For aesthetic or symmetry reasons, more posts may be added.
How many footings do I need for a 12×12 deck?
For an attached 12 x 12′ deck, you’ll need at least 3 footings, plus at least 2 more if you’re planning on building stairs with it. If your deck will be a different size, it’s easy to figure out how many you’ll need.
How many posts do I need for a 10×10 deck?
A freestanding 10′ x10′ deck needs 4 posts, supporting two pairs of 2-ply non-incised 2×8 beam, upgrading the beam to 3-ply using incised wood.
Do freestanding decks need footings?
According to the main code provision for footings, the only requirement for building a deck that is freestanding is that it must have a minimum footing depth of 12 inches below the undisturbed ground surface. There is no need to extend a footing below the frost line, as is required for standard decks.
Do I need concrete footings for a deck?
Large decks that are attached to the house should always have footings because they act to spread the heavy load of the deck from the surface of a support post over a large surface of the soil so the ground can adequately support it. The footings ensure that the deck will not fall, tip or rot away after a few years.
How many support beams do I need for a deck?
For a deck that is 15 feet wide with 2×10 joists spaced at 16 inches apart, you have two options. You can use two beams, one at 7.5 feet and one at 15 feet, to provide support.
Should I concrete my deck posts?
A deck post should always be placed on top of footing, not inside concrete because it can break. When concrete is poured around a deck post in this way, the post will rot due to moisture buildup by the soil.
How many 4×4 posts do I need for a deck?
You’ll need approximately one 8-foot 4 x 4 for every two deck posts. You’ll need one deck post connector and through bolt for each post. Consult your plans and local building code for code-approved hardware and connection methods. Railings: There are many railing options available in a variety of styles.
What material do I need for a 12×12 deck?
You will need 18 boards of 2-by-6-inch lumber or nine 2-by-10 inch boards to build the joists, also known as the beams. You should purchase an additional 25 percent wood to allow for framing pieces and waste.
Where do you place footings on a deck?
Deck footings have to be placed just right so that the posts they support land in the center of each footing. Pay attention to the framing plans. They might not call out the location of the footings, but they will at least show the centerline of the beam and the spacing of the posts.
Is 4×2 OK for decking?
4 x 2 Timber Rail / Joist These decking joists are the most common sized framing timber for decking. They provide a solid structure for fixing your decking boards too. When making your decking frame you should use a 400mm spacing between your timber joists.
How many posts do I need for a 12×16 deck?
A standard deck will need four footings parallel to the house, but they will need to be temporarily braced by 6 inch-by-6 inch posts.
Can I use 4×4 posts for a deck?
In the past, many decks were built with 4×4 support posts (also called structural posts). But these can bow seriously, even if a deck is only 3 feet off the ground. For that reason, we strongly recommend that you use 6x6s instead, even if your building department does not demand them.
What is the average cost of a 12×12 deck?
A 12 x12 deck can range in cost from $2 200 to $13 000, but the average will be $6 000. Costing $40 a square foot but can be as little as $15 or as high as $85, depending on the deck’s features. A pressure treated deck is the most economical, with composite being the more expansive option.
Can I use deck pier blocks instead of footings?
Pier blocks can be used instead of footings for a ground-level deck not requiring permits. Any decks higher than 24” require concrete piles 10” in diameter and 48” below grade. These footing size requirements are to ensure enough soil bearing to prevent the joist from sinking in the ground.
