Table of Contents
Your cast is made of a substance called Plaster of Paris. It can take up to 48 hours to completely dry. It is important that you do not knock or put pressure on your cast whilst it is drying, as this may crack or dent it. It is important you elevate (raise) your injured limb as much as possible for the first 48 hours.
How long does it take for a cast to dry?
Fiberglass dries in 15 to 30 minutes, but plaster can take longer. If you are walking on the cast or splint, the drying time will be longer. On average, plaster will take about a day and a half before it’s hard enough to support your weight, but fiberglass will take about 20 to 30 minutes.
How long do you keep a plaster cast on?
Plaster casts are made up of a bandage and a hard covering, usually plaster of paris. They allow broken bones in the arm or leg to heal by holding them in place, and usually need to stay on for between 4 and 12 weeks.
What’s the difference between a hard cast and a soft cast?
What are casts made of? The outside, or hard part of the cast, is made from two different kinds of casting materials. Cotton and other synthetic materials are used to line the inside of the cast to make it soft and to provide padding around bony areas, such as the wrist or elbow.
How do you dry a plaster cast?
Plaster casts will dry in time, of course, by simply exposing them to air at room temperature. Most often, however, they are dried in a warm, forced-air oven, at about 150 degrees F. Higher temperatures tend to crack casts and produce spalling. In our experience the times generally required for drying in 150 degree F.
Does plaster heat up when drying?
Plaster casts will rarely become 100% dry without the use of a forced air dryer. As the cast sets or hardens, a chemical reaction causes the piece to heat slightly.
How do you scratch an itch in a cast?
It can be maddening if you can’t reach a spot you need to scratch. Locate your itch, and tap it on the outside of the cast. You can also try blowing cool air from a hair dryer around the edges of the cast. Don’t give into temptation and stick a pencil, a ruler, or any other objects inside the cast to relieve the itch.
Can you sleep on your side with a cast?
Do I really need to elevate my cast when sleeping? Yes. This is probably the most important thing to remember when sleeping with a cast, no matter what bone you’ve broken. Keeping the injured bone elevated above the heart prevents blood from pooling around the break which can cause painful swelling.
What happens if cast gets a little wet?
In general, casts are meant to stay dry. A wet cast can lead to skin irritation or infection. Plaster casts and fiberglass casts with conventional padding aren’t waterproof. Keep your child’s cast dry during baths or showers by covering it with two layers of plastic, sealed with a rubber band or duct tape.
How do you dry a cast fast?
If your cast does get wet, use a hair dryer to warm the cast and speed up the drying process. A wet cast may cause skin problems.
What happens if you leave a cast on too long?
While it may not seem like too much of an issue, putting a cast on a patient too tight can actually cause permanent damage. This is because a cast that is too tight will restrict blood flow to the limb, will put excessive pressure on the nerves, and may even cause atrophy of the muscles or tendons in the limb.
Can a bone move in a cast?
A cast, which keeps a bone from moving so it can heal, is essentially a big bandage that has two layers — a soft cotton layer that rests against the skin and a hard outer layer that prevents the broken bone from moving.
How do you sleep with a leg cast on?
If it is your Leg, take some large pillows such as your large couch or chair cushion and place it on your bed. Lie flat on your back and have the leg propped up on the pillow. Keep adding the pillows until your leg is at least 10cm (over 1.25 inches) above your heart level.
What is a temporary plaster cast?
A temporary cast has been applied to your injured limb to hold it in one position until you are seen in the trauma outpatient clinic. Your cast is made of a substance called Plaster of Paris. It can take up to 48 hours to completely dry.
What happens if you fall with a cast on?
You may damage your skin, compromise the stability of the cast, or accidentally drop the object into the cast causing more discomfort. Don’t apply lotions, powders or deodorant to the skin under the cast. They may cause bacteria growth. If you notice red or raw skin under your cast, contact your provider.
Is it normal to have pain while in a cast?
Because bones, torn ligaments, tendons, and other tissues can take weeks or months to heal, you may be stuck with your cast for a while. Although the pain may ease after a few weeks, the discomfort – swelling, itchiness, or soreness – may last the entire time.
Should I wiggle my toes in a cast?
Try to keep the area around the edge of the cast clean and moisturized. Wiggle your fingers or toes while wearing a cast or splint. This helps with circulation. You can apply ice for 15 to 30 minutes over a cast or splint.
Will my cast loosen up?
Keep your plaster cast dry at all times, or it will “melt.” If it gets wet, it may soften or crack and lose its proper position.
Is a bone completely healed when a cast comes off?
During this “remodeling”, the body can straighten the fractured bone by laying new bone on the inside edge, and taking away bone on the outside of the angled area. In young children, bones can remodel fairly large angles, healing to appear completely normal within one to two years.
