Table of Contents
Moving a toilet is not so much about moving the actual fixture—in fact, installing a toilet is a simple job that takes less than an hour—as it is about moving the drainage and the water supply plumbing to the new location. Once all of the plumbing is in place, installing the toilet is a relatively easy task.
Is it difficult to relocate a toilet?
Moving a toilet is not a straightforward weekend DIY job, but it is very doable when you involve the professionals. Once the toilet itself is removed, your plumber will have to move the drainage, as well as the water supply to accommodate the new location.
How do you move a toilet by yourself?
How to Move a Toilet in 8 Simple Steps Make a plan. Make space for the toilet before you move it. Turn off the water. Remove remaining water. Disconnect the supply line from the toilet. Remove the bolts. Remove and move the tank. Remove and move the toilet bowl. Clean and plug the drain hole.
How much does it cost to relocate a toilet?
Cost of Moving Plumbing Fixtures The cost to move a toilet or sinks can be $2,500-$3,500 per fixture. Plumbing can be a significant cost factor in a remodel when a bathroom floor plan is altered. The toilet is the most expensive to move.
Can you relocate a toilet?
Yes, you can actually move a toilet. Even moving a toilet by a few inches without having to make a new hole in the floor is possible. You can use an offset toilet flange to move the toilet by a couple of inches on any side. This will allow you to use the same wastewater line and in turn help to save you a lot of money.
Can you put a toilet anywhere in your house?
On a serious note, it is absolutely possible to install a toilet, even a bathroom as a matter of fact, anywhere in your house. In the past, many homeowners have had the idea of their dream bathroom crushed because the location was simply too far away from the main drain.
Can you move a toilet to where a shower was?
Can you put a toilet where a shower was? The simple answer is yes, you can put a toilet where a shower was, but the move doesn’t come without its issues. This isn’t a simple DIY job. You are going to have to remove at least one wall and, hopefully, only a small portion of the floor.
How heavy is a toilet?
A standard one-piece toilet weighs about 88 pounds (40kg), whereas a two-piece toilet weighs about 55 pounds (25kg). A one-piece toilet weighs significantly more because the toilet and tank are fused together while a two-piece toilet consists of a separate toilet and tank joined together with fittings.
How much does it cost to move a toilet on a slab?
Although the cost of the toilet itself is not nearly as much as a tub or shower, the expensive part is the pipes. Just running the pipes is typically about $1,500 to $3,500.Moving the Toilet. Brand Cost Kohler $200 to $800 Toto $225 to $1,000 Saniflo $300 to $1,200.
How expensive is it to move plumbing in a bathroom?
On average, it costs somewhere between $500-$1,000 to move a plumbing fixture around three feet or more. This varies, of course, depending on if your plumber needs to move anything around to connect to your drain, vent, or water lines.
Can you move plumbing in a bathroom?
While it’s possible to move almost any large fixture, beneath the bathroom floor are supporting joists that you should not cut in order to install new drains. Design your new configuration so that the new drainpipes run parallel to the joists and between them.
How far can a toilet be from the main stack?
If the toilet is less than six feet from the stack, tie the waste line from the new toilet directly into the stack. The toilet can be as far as 10 feet from the stack if the waste line is 4 inches.
How much does it cost to move a toilet Australia?
Every property in Australia is unique so the cost to move a toilet can vary from $100 to many $1,000’s depending on the property type & layout. What will vary greatly is the time, tools and materials needed to complete any type of toilet move whether that is a wooden floor board or concrete slab.
How do you move a toilet drain pipe?
Can you have a toilet without plumbing?
A Saniflo is normally installed in a domestic property where there is no mains drainage pipe available. This means you can have a toilet anywhere, without worrying about mains drainage. You could install a downstairs toilet under your stairs, create an ensuite bathroom or even install a toilet in your basement.
Do you need planning permission to add a toilet?
Usually, adding a downstairs toilet to your home does not require planning permission, unless it is part of a larger extension. Speak to your planning consultants and they can advise you on where you stand with planning permissions. Your new toilet will have to adhere to building regulations.
How hard is it to add a toilet to a house?
A cosmetic renovation of an existing bathroom can be completed pretty quickly. A more comprehensive renovation typically takes around four and a half to nine weeks. If you add on to the footprint of your home to add a bathroom, then you can expect the job to take quite a bit longer.
Do showers and toilets use the same drain?
A toilet and shower can share the same drain but they cannot share a waste trap arm for sanitary reasons. Both shower and toilet wastewater go to water treatment facilities, but shower water used to drain outdoors. Below, we will get into why these drains are typically separate.
Is shower drain connected to toilet?
The toilet and shower drain are connected to the main pipe. The outside of the main sewer drain is connected to the shower and Toilet Drain. The extra waste-water comes from your home to the main sewer line.
