Table of Contents
New tires typically come with 10/32” or 11/32” tread depths, and some truck, SUV and winter tires may have deeper tread depths than other models. The U.S. Department of Transportation recommends replacing tires when they reach 2/32”, and many states legally require tires to be replaced at this depth.
Should I replace tires at 4 32?
The Tire Rack’s advice is that if rain and wet roads are a concern, you should consider replacing your tires when they reach approximately 4/32″ of remaining tread depth. Since water can’t be compressed, you need enough tread depth to allow the rain to escape through the tire’s grooves.
Is the penny test for tires accurate?
For years, motorists have been told the “penny test” is an accurate indicator of whether or not you need new tires. The test is conducted by sticking a penny head down in a tire tread; if you see all of Lincoln’s head, then you should change the tires. The one with an eighth of an inch of tread stopped in 300 feet.
Is 9/32 A good tire tread depth?
Average new tires used on cars typically start with 10/32″ to 11/32″ of original tread depth. As mentioned above, tires are legally “worn out” In most States when they reach 2/32″ of remaining tread depth. For example, a typical tire that starts with 10/32″ of original tread depth has only 8/32″ of useable tread depth.
How many 32nds are in a new tire?
In the United States, tire tread depth is measured in 32nds of an inch. New tires typically come with 10/32” or 11/32” tread depths, and some truck, SUV and winter tires may have deeper tread depths than other models.
What is a good tread depth for used tires?
Used tires tread can be up to 90%, but the average is 6-8/32”. Tires in good condition should have a minimum of 6/32” to be useful, or 4/32” if the tire is 13-14”. The average legal minimum tread depth is 2/32”, but driving becomes unsafe with such a tread.
How many miles are tires good for?
Your tires should last 50,000 to 60,000 miles on average. But that really depends on the manufacturer. Some manufacturers build their tires to last up to 80,000 miles, while some design their tires to last as little as 30,000 miles. You can see how many miles to expect out of a tire by checking its treadwear rating.
How often should your tires be rotated?
This common maintenance task—which should typically be done every 5,000 to 8,000 miles—isn’t one you should ignore. It may seem minor, but remember: Tires are the only thing that comes between your 2-ton vehicle and the road.
How often should tires be replaced?
When Should You Replace Your Vehicle’s Tires? As a general rule, the National Highway Traffic Safety Administration (NHTSA) recommends that drivers change the tires on their vehicles every six years.
Is 80 percent tire tread good?
Here’s what the heck that means: 2/32nds of tread is the legal minimum of tread you need on your tires to pass inspection in most states. Most tires have 10/32nds of tread when new, and when 80 percent of the tread has worn down, or its reached 2/32nds, it’s time for new tires.
Is 7 32 A good tire tread depth?
A tread depth gauge is the most accurate way. 6/32″ or higher: Your tire’s tread depth is sufficient. 5/32″: If snow-covered roads are a concern, you should consider replacing your tires. 4/32″: If you frequently drive on wet roads, consider replacing your tires.
Is 7 32 tread good for winter tires?
According to tire manufacturers, and even the law in most provinces, your tires should be replaced when the tread depth reaches 4/32” in the winter. If your tread depth wears to those levels, your tires are considered bald and a safety hazard. Use this chart as an example: 50 percent worn – 7/32” REPLACE TIRES.
What is a good tire tread depth in mm?
While the minimum legal tread depth for all passenger car tires in the US is 2/32” (1.6 mm), it is safer to replace them at a depth of at least 4/32” (2 mm). For winter tires, it is recommended that you replace your tires when the tread depth is below 15/64” (4 mm).
What percent tread is 5 32?
This means you have 5/32 of 1 inch of tread remaining on your car tires. On most passenger car tires, this represents approximately 60% wear so you may want to start thinking about choosing a replacement set.
How good is 6 32 tread?
6/32” Your tire’s tread depth is sufficient for 3-seasons but nearing minimum for a winter tire. 5/32” If wet roads are a concern, consider replacing your tires. If it’s a winter tire, 4/32” is the minimum. 2/32” Your tires are legally bald and need to be replaced.
Is 50 percent tire tread good?
If the tread reaches the bear’s paws, your tires are probably pretty new. If it reaches all the way across the silver, they’re about 50% worn. If your tire tread reaches only about half-way into the letters, it’s time to shop for new tires.
Is 5mm tire tread good?
Insert the gauge into the tyre tread groove with the coloured scale touching the tyre. If the red is visible the tyre tread is below 1.6mm. This means the tyre is 100% worn and should be replaced urgently. If the green is visible, the tyre tread is above is 5mm and is safe to drive.
What is the minimum tire tread depth in Canada?
Tread Depth Requirements Canadian law requires a minimum 1.6 mm tread depth, but some provinces have even stricter requirements.
Why do new car tires wear out so fast?
The tires that came with your last new car were not designed by Michelin, Goodyear, Bridgestone or any other tire manufacturer. They were designed by the manufacturer of your car. This is because virtually all auto manufacturers specify very soft rubber which means they wear out too fast.
Are 10 year old tires safe?
Old tires are dangerous, regardless of tread depth. While there’s no federally sanctioned safety guidance on when a tire is too old to be safe, many carmakers recommend replacement at six years from the date of manufacture. An analysis of the used tire revealed that it was nearly 10 years old.
How can I make my tires last longer?
How to: Make Your Tires Last Longer Check Your Tire Air Pressure Monthly. Take the easiest step to extend tire life: Maintain the correct air pressure. Get Your Tires Rotated Every 5,000 Miles. In most cars, only one or two wheels “drive” the car at a time. Have Wheels Balanced. Check Your Alignment Twice a Year.
