Table of Contents
If you cannot see the top of water in your well then you can tie a fishing float or “bobber” to your string and lower it carefully into the well until it stops dropping. Mark the string at ground level. Measure that string length – that’s the depth from the ground surface to the top of your well water.
How do I find out my well depth?
How to Measure Lower until you feel slack. Note, you may feel some bouncing as you pass the pump depending on the space from the casing to the weight on the measuring line. Mark the line at the top edge of the casing. Pull out and measure. This is your well depth – the distance to the bottom of the well shaft.
How far down is a deep well?
Most household water wells range from 100 to 800 feet deep, but a few are over 1,000 feet deep. Well yields can be increased by fracturing the bedrock immediately around the drill hole and intercepted rock faults.
How do I find the water table in my area?
How to Find My Water Table Call your local County Extension Office. It may have statistics for the average annual water table level in your area. Look online. Check out the website for your local Water Resources Office. Dig. This is the most reliable way to find the water table level on your land.
How many years does a water well last?
The average lifespan for a well is 30–50 years. 2. How deep is the well? Drilled wells typically go down 100 feet or more.
How far down do you have to drill to find water?
You will need to dig at least 30 feet below the surface to find high-quality water. But you’ll need to dig even deeper to find better water that will be the safest for your family to drink.
Does a deeper wells mean better water?
Do Deeper Wells Provide More Water? Confession—The deeper the well doesn’t really guarantee you will have more water volume or pressure. If you have a shallow well, it means that your water source is relatively close to the ground’s surface.
Is it OK to drink well water?
Well water can be safe for drinking and all other household needs, as long as you make sure to test your water supply regularly and select treatment solutions in line with your results. Learn more about the well water treatment options that are available for your specific needs.
How can you tell if there is water underground?
The ground penetrating radar (GPR) system is used for underground water detection. GPR is a promising technology to detect and identify aquifer water or nonmetallic mines. One of the most serious components for the performance of GPR is the antenna system.
Do wells run out of water?
When a well “runs dry” it doesn’t mean that the well will never produce water again. Aquifers can recharge through a combination of more precipitation and less pumps pulling water out of that aquifer. Sometimes wells can run dry permanently, but that is quite uncommon.
What are the disadvantages of well water?
Disadvantages of well water include: Hard Water and Scale Buildup. Harmful contaminants such as bacteria, lead, and arsenic. Pumps need to be replaced every 10 or so years. Bad taste.
How often should I clean my well?
9. As a routine maintenance practice, clean your well at least once a year. If you have an iron or sulfur bacteria problem, clean more often.
How far from the bottom of a well should the pump be?
Pumps should never be set directly at the bottom of a well. It is usually best to place the pump 10 to 20 feet up from the bottom of the well.
How far away from your house can your well be?
Any contamination in your neighbor’s well can travel into your well. Some activities legally require more than a 50-foot zone of protection. As a general guidance, personal drinking water wells should have a minimum horizontal distance of at least 10 feet and preferably 25 feet from such boundaries.
Will you always find water if you dig deep enough?
The Deepest Drilled Hole on Earth This groundwater may be the result of stray oxygen and hydrogen atoms being pressed from rock minerals. So, if you dig deep enough down into the Earth’s crust, you’ll certainly find water, but no one realistically wants to drill straight down into the center of the Earth to find water.
How many gallons per minute is considered a good well?
5 gpm (two fixtures running simultaneously at 2.5 gpm) is a good estimate of peak demand, for the typical household. Water wells that reliably yield 5 gpm should be able to meet peak and daily needs for most residences. Wells yielding less than 5 gpm, however, are sometimes the only water source available.
What is considered a good producing water well?
A well yield of 5 gallons per minute of sustained flow (measured over 24 hours or over 5 hours in some standards) is considered by most authorities as adequate for a one family residence.
Why does my well water smell like poop?
Can well water that smells like feces be harmful to bathe in or drink? – Quora. Foul smell indicates the high BOD level of water which is not useable even for personal hygienic work. It means this water is not useable for drinking purpose too. Water in well is stored from a very long time without it’s use.
Can you shower in well water?
If your water at home is from a private well or small community well, you should boil the water or use approved bottled water for drinking. Sometimes a well is more likely to become contaminated with bacteria. Bathing is not a problem using well water.
