Table of Contents
The standard depth of a vanity, from front to back, is typically between 20 to 21 inches. However, there are narrow depth options available which are usually 18 inches. While there isn’t necessarily a standard for vanity height, you will typically find them in the range of 32 to 36 inches tall.
What is the standard height and depth of a bathroom vanity?
For a single vanity, the most popular widths are 24″, 30″, 36″, 48″, and for double vanities the most popular widths are 60″ and 72″, but start at 48″. The standard depth of a vanity is typically around 20″, but narrower options are available. The standard vanity height is 32″, but ranges from 30″ – 36″.
What is the smallest depth for a bathroom vanity?
While most bathroom vanities measure around 17 inches to 24 inches deep, the standard bathroom vanity depth is 21 inches. For smaller bathroom spaces, narrow depth bathroom vanities are available that measure less than 18 inches deep.
What is the best depth for a bathroom sink?
Most round bathroom sink bowls are 16 to 20 inches in diameter, while most rectangular sinks are 19 to 24 inches wide and 16 to 23 inches front to back. The typical basin depth is 5 to 8 inches.
How is vanity depth measured?
Take a measurement at the widest part of the variety in contact with the the floor, which is your base width. Then, measure across the countertop, which is your top width. Next, to get the depth dimensions of your vanity, take base and top measurements.
How shallow can a vanity be?
The standard vanity depth is 21 inches. But you can gain floor space in a small bath by trimming at least part of the vanity to 18, 15, or even 12 inches deep.
How shallow can I make a vanity?
Shallow-depth vanities are those that measure between 17 and 20 inches deep. These slim vanities can be any width or height since depth is the concern. This vanity offers two sinks, three drawers for storage, and built-in electrical outlets and USB outlets for easy device and bathroom appliance use and charging.
What are bathroom vanity heights?
Traditional vanity heights in older homes range from 30 to 32 inches up from the floor. The modern trend is toward higher vanities, up to around 36 inches. For reference, that’s the standard counter height for kitchens.
What size sinks for 72 inch vanity?
One-of-a-kind concrete sink with vanity. See it on Etsy. Cabinet Width Cabinet Depth (Standard) Max Sink Size (With NO counter space) 36″ 21″ 33″ 48″ 21″ 34″ 60″ 21″ 34” or 19” x 2 for double sinks 72″ 21″ 34” or 19” x 2 for double sinks.
Is bathroom sink water safe to drink?
Although municipal water services ensure water is fit to drink and use without fear of getting sick, avoid regularly drinking from the bathroom sink. There is a risk of contamination from bacteria in the reservoir or tank, especially the hot water.
How much overhang should a bathroom countertop have?
The standard overhang for a bathroom countertop is about 1 to 1 1/2 inches from the cabinet. A bathroom countertop that is surrounded by walls is typically flush with the boundaries and has no overhang except the inch or more in the front.
How much space does a bathroom vanity need?
Clear floor space NKBA designers recommend a 30″ clearance between the front edge of a fixture, such as a vanity or toilet, and any other fixture or wall. The building code allows for a minimum of 21″.
What is standard countertop depth?
While the standard kitchen countertop depth is 25 ½ inches, most kitchen island countertops can go up to 27 or 28 inches deep and over 30 inches deep if it comes with a breakfast bar. The island countertop depth depends on the availability of space.
Why are bathroom counters so low?
The only reason bathroom counters were lowered was to make the sink accessible for small children. While it’s not entirely impossible for them to use the sink, it could make it more difficult for them to wash their hands. For kids bathrooms, you can install standard height vanities.
How deep are bathroom wall cabinets?
The standard measurements for bathroom cabinet depths are as follows: Most lower bathroom cabinets and vanities range between 21-22 inches. Sometimes you’ll find 18-inch depths. Medicine cabinets are typically about 4 inches deep, whether recessed or mounted on the wall.
What is the narrowest vanity?
Beverly Single Bath Vanity – 14″ Depth The Beverly Single Bath vanity is one of the narrowest vanities at 19″D yet still holding plenty of storage space for all your personal accessories.
Are bathroom vanities the same height as kitchen cabinets?
Bathroom cabinets typically run shorter than kitchen cabinets with a height of approximately 31 inches tall. While bathroom cabinets can be custom designed to match the height of kitchen cabinets, the most common practice is to have them stand at 31 inches tall.
What is the tallest bathroom vanity height?
If you haven’t done a bathroom remodel in years, you’ll notice that vanities have gotten taller. They used to be around 32″ tall, and now they’re 36″ to match the height of kitchen countertops. This additional height looks more modern and offers extra storage space.
How big is a small bathroom sink?
Small bathroom sinks or washbasins are any sinks measuring between 15 inches to 20 inches. But there are also petite sinks that are under 15 inches long.
What is the depth of a basin?
This is the distance from the rear of the basin to the front. Then, on the exterior of the basin, measure from the top to the bottom. This will give you the height. Finally, measure the depth.
How do you measure a sink for a cabinet?
Lay the tape measure along the bottom of the cabinet; place the end against the back of the cabinet, then pull out the tape until the front edge of the cabinet to find the front-to-back (depth) measurement. Next, measure the total outer width of your cabinet.
