Table of Contents
The most common problem here is likely an issue with the batteries. If the battery is low on power or doesn’t distribute power properly, then the cart may jerk as it accelerates. Thankfully, replacing the battery should be a good enough fix to manage this problem without difficulty.
What causes a electric golf cart to jerk?
The most common reason for your golf cart jerking is often the battery terminal connections are loose and/or corroded. A poor connection prevents the correct amount of current from flowing through the set of batteries to your speed controller (or resistor coil), and ultimately to your electric motor.
How do I know if my golf cart controller is bad?
X Common Symptoms of Controller Failure Top Speeds Not Appropriate for Your Cart. Golf carts are designed to reach pretty specific speeds and to not go over them or beneath them. Sudden and Unexpected Slowing. Shuttering or Shaky Driving. Stalling Out and Refusing to Start. Surges in Speed When Driving.
How do you test a golf cart MCOR?
To test the MCOR, look for the line item that says THROTLE. With the cart in neutral, slowly depress the gas pedal. You should verify that the throttle moves from 0% to 100% in a smooth manner. If you see it jump around (ie.
Why does my golf cart jerk when I accelerate?
The most common problem here is likely an issue with the batteries. If the battery is low on power or doesn’t distribute power properly, then the cart may jerk as it accelerates. Messing up the clutch or the MCOR is going to cause your cart to become even more jerky.
Why does my electric golf cart go slow uphill?
The Reason Your Electric Golf Cart Goes Slow Uphill? Your electric golf cart can struggle on inclines for a variety of reasons. Weak batteries, incorrect tires, and wear and tear to the motor and wiring are all potential causes of your cart’s slow speed.
How do I know if my electric golf cart motor is bad?
You have enough going on in your life without your golf car refusing to start when you turn the key in the ignition. If your golf car won’t start, is slower than it used to be, or is experiencing other technical problems, you could have a bad motor on your hands.
How do you test an electric golf cart controller?
Connect the negative probe to the controller’s M terminal and positive probe to the B+ terminal. Press the accelerator and watch to see if the voltage increases. It should increase from a reading of 0 to the full voltage of the battery. If the motor is not turning, the problem may be in the directional switch or motor.
How do you troubleshoot an electric golf cart?
How to Troubleshoot an Electric Golf Cart Test the wall socket where you charge your cart. Every golf cart has a built-in charger that connects to a wall socket. Expose your golf cart batteries. Test the batteries for voltage. Replace dead batteries. Expose the motor for inspection. Reset the motor. Test the cart.
What does a MCOR on a golf cart do?
Club Cars use an MCOR throttle device. This translates your foot movement at the pedal into electric impulse that the motor controller reads. MCOR stands for “Motor Controller Output Regulator”.
Where is the MCOR located?
This MCOR is located under the passenger’s side floor board and is connected to the accelerator pedal via a rod.
What does MCOR stand for?
MCOR Acronym Definition MCOR Methodist Committee for Overseas Relief (now United Methodist Committee on Relief) MCOR Marine Corps MCOR Multi-Cultural Outreach Roundtable (est. 2002; Plano, TX).
How do you align a golf cart?
Loosen the tie rod on the driver’s side wheel and adjust the toe in by twisting the rod left or right depending on the direction you need to adjust the tire. If you need to adjust the tire inwards (towards the front of the cart) then turn the rod towards the rear of the cart, which will turn the tire in.
How do you tighten the steering on a golf cart?
Move the rack to one side by turning the wheel slightly in one direction. With the help of a large wrench, loosen the bottom adjustment nut on the golf cart. Tighten the middle adjustment nut with a flat screwdriver or an Allen wrench. On some carts, this could also be a screw or bolt.
How do you test a throttle inductive sensor?
Put the key in the “On” position in your Run/Tow switch on the cart. Switch the F/R switch into a forward position to test your cart. Place your voltimeter testing pins on the throttle pins to see how much voltage you get. When the cart is running with no throttle, you should get about 10 volts here.
Is ezgo a good golf cart?
EZGO’s are well designed, have a steel frame, and are very durable. EZGO replacement and aftermarket parts are fairly inexpensive and easy find and purchase. The EZGO has a smooth ride and offer plenty of options and upgrades to turn a basic cart into the electric vehicle you need.
How does a golf cart solenoid work?
Solenoids are Simple, But Powerful Every time you turn your cart on or press the pedal, a small amount of voltage passes along the wire coil and triggers the steel plunger to close. This process allows energy from the battery to directly contact your golf cart’s motor so that it can run properly.
