Table of Contents
Mathews Halon 32 and the Triax use the same draw length modules. So, to change draw length, the cam stays the same, and you swap out/swap in a different draw length module. So, the Triax has draw length modules that go from 24.5 inches of draw length (Module L) up to 30 inches of draw length (Module A).
Does Mathews Triax have adjustable draw length?
The draw lengths offered on the Triax range from 24.5-30.5-inches, and can be adjusted in half-inch increments within that draw length range.
Can you adjust Mathews draw length?
With the exception of the Mathews Mission series, Mathews bows are designed draw length specific, and do not provide for setting adjustment. While the Mission series draw length can be changed with a setscrew on the cams, you will need to replace the cams to change the draw length on other models of Mathews bows.
How do you adjust the draw length on a Mathews bow?
The draw length on your bow is adjustable on the cam a maximum of one inch down from the peak draw length. This is accomplished by moving the string loop to any of three adjustment posts on either side of the cam.
Which bows can be adjusted for draw length?
Adjustable cams allow the archer to adjust his or her draw length with the use of an hexagonal wrench without, in most cases, pressing the compound bow. Adjustable compound bow cams allow archers to adjust anywhere from 3 inches up to 13 inches depending on the compound bow.
Is the Mathews Triax worth it?
The Triax is not only quiet, but it actually feels like it as well! The Triax is the most vibration free bow that I have every shot, and that is saying a lot because the majority of Mathews bows over the last decade have been very efficient and very vibration-free.
Which is better Triax or vertix?
Mathews sets the bar higher than ever with its new-for-2019 VERTIX. The new 30-inch Mathews VERTIX (above) is 2 inches longer than the TRIAX. With the TRIAX measuring just 28 inches between the axles, I found it to be compact and maneuverable. I hunted with the TRIAX a lot this past year.
How much does the Mathews Triax weight?
Weighing 4.46lbs with an axle to axle length of 28 inches, the TRIAX is a hunting bow that should not be overlooked. Available in three different peak draw weights of 50, 60 and 70 lbs.
How do you change the draw length on a Mathews no Cam?
Simply remove the two allen screws that hold the module to the wheel and install your new module in it’s place. As noted earlier these modules can change both your draw length as well as your let-off, which will change your bow’s speed. The lower the let-off the faster the bow.
How long should my draw length be?
Resist the temptation to make your draw length longer than it should be, as this will effect your accuracy. Your wingspan typically is the same as your height in inches; So your height in inches minus 15 and then divided by 2 will be your draw length, or at least a very good starting point.
What is the fastest bow Mathews makes?
The XLR8, with a 5-inch brace height and 360 IBO, stands to this day as the fastest “Mathews” compound bow ever made.
Does draw length affect draw weight?
Yes, changing to a longer draw length on a bow increases the draw weight. Reduce the draw weight with the oimb bolts if you can.
Is 70 lb draw too much?
For example, a bow with a 70-pound peak weight and a 80% let-off should have a holding weight of around 14-pounds. Being able to hold a bow at full draw for 30 seconds is great, but if you’re shaking, struggling, and exhausted at the end of that time, then you’re not going to be able to make an ethical shot.
How do I know if my draw length is too long?
The bow arm should move toward the target when the shot is fired. If the bow arm drops or swings to the side, the draw length is probably too long. When this happens, the scapula has already pushed the bow arm out as far as it can extend before the arrow is released.
Is the Mathews Triax forgiving?
The most forgiving compact bow I have ever shot, hands down. Extremely surprised as this one continues to impress.
What year is a Mathews Triax?
The 2018 TRIAX is highly maneuverable, deadly accurate and the quietest, most vibration-free bow Mathews has ever built. The TRIAX operates off a 28″ ATA platform with a 6″ brace height, and is powered by the award-winning, highly-efficient and extremely accurate Crosscentric™ Cam system producing speeds up to 343 fps.
What colors did the Mathews Triax come in?
The design team changed the geometry of the bow and engineered what they call 3D damping technology – virtually eliminating felt recoil and making the bow extremely quiet at the shot. The bow also comes in 7 finishes; Black, Gray, Lost Camo XD, Ridge Reaper Barren, Sitka Elevated II, and Sitka Subalpine pattern.
Whats the difference between the Mathews vertix and VXR?
In my honest opinion, the VXR is a shorter version of the Vertix. If I had a 28″ or shorter draw length, and was shopping for a new bow I would buy the VXR all day long. If I bought the Vertix last year, and love it, then there is no need to buy the VXR. I would hold onto the Vertix.
What bows did Mathews make in 2019?
The 2019 VERTIX is the peak of versatility and performance. Switchweight modules allow you to change peak draw weight in 5 pound increments. Available in 60, 65, 70 and 75 pound peak weights, each set of mods are programmed for an incredibly smooth draw.
