Table of Contents
To adjust the draw weight on a compound bow, take it to an archery shop. A bow technician will evenly tighten the limb bolts and check the draw weight. One full turn of the limb bolts usually changes its weight about two pounds. By increasing your draw weight just a few pounds at a time you’ll avoid injury.
Is 70 lb draw too much?
For example, a bow with a 70-pound peak weight and a 80% let-off should have a holding weight of around 14-pounds. Being able to hold a bow at full draw for 30 seconds is great, but if you’re shaking, struggling, and exhausted at the end of that time, then you’re not going to be able to make an ethical shot.
Can you shorten the draw on a compound bow?
Adjustable cams allow the archer to adjust his or her draw length with the use of an hexagonal wrench without, in most cases, pressing the compound bow. Adjustable compound bow cams allow archers to adjust anywhere from 3 inches up to 13 inches depending on the compound bow.
Does draw weight increase accuracy?
Yes, most shooters are more accurate with lesser draw weight. A time proven fact that most shooters refuse to accept.
Does brace height change draw weight?
no. When you get to the end of your draw length it should be the same. But the preload is higher so the weight when you start to draw starts heavier as you alluded to.
What draw weight do most hunters use?
Some shooters are capable of shooting 70, 80 or 90lbs, but most adult males shoot between 60 and 70lbs. Today’s bows are extremely efficient and 40lb compound bows are more than capable of harvesting many big game animals. For whitetail deer hunting anything above 40 lbs is fine.
How do I know if my bow draw is too long?
The bow arm should move toward the target when the shot is fired. If the bow arm drops or swings to the side, the draw length is probably too long. When this happens, the scapula has already pushed the bow arm out as far as it can extend before the arrow is released.
How do I know if my bow draw length is too long?
The ideal draw length for you is the one that allows you to anchor in a comfortable position, with your bow arm elbow unlocked (slightly bent) and your release arm elbow and forearm pointing straight away from the target. If the release arm elbow points left or right, your draw length is too long or too short.
How do I know when to increase draw weight?
But, generally speaking, increasing poundage by 2 to 4lb whilst shooting regularly (twice a week) is the way to go. Once you feel fully in control of the bow you can increase by a couple or a few pounds.
When should I move up my draw weight?
The simple answer is: It’s time for an archer to increase their draw weight when: Your muscles are able to comfortably shoot your bow for a long time with no fatigue. You need to shoot further distances than your current draw weight allows, or… Your arrows are consistently falling short of your targets.
Do heavier bows shoot farther?
Heavier arrows will not travel as far because they will be pulled down by gravity, but they will be more accurate than lighter arrows and deliver a more penetrating impact to the target. The range of a heavier arrow will be less than that of a lighter arrow.
How does riser length affect draw weight?
The longer the riser, the more draw weight you loose. The shorter the riser the more draw weight you gain. Most standard ILF limbs are rated on either a 17″ or 19″ riser, and most manufacturers will tell you in the limb info what riser length they are rated on.
Can you change the brace height on a compound bow?
To adjust brace height, unstring the bow, remove the bottom string loop, and then twist or untwist the string. If your brace height is too low, give the bowstring two twists to increase the brace height by about ¼ inch. If your brace height is too high, unwind a few twists from the bowstring.
Does brace height really matter?
It’s long been said that brace height is a key factor in a bow’s accuracy. Shorter brace height bows tend to have the reputation of being tough to tame. Instead of a bow with a 5″ brace height they would select a bow with a 6″ or 7″ brace height to maximize their accuracy.
What is the best let off on a compound bow?
A standard compound bow will have let off of between 60% to 90%. These are just a rule of thumb though, and it does vary between different models. Some bows even have a feature of a changeable let-off percentage.
How hard is it to pull back a 40 pound bow?
The draw weight is basically, “How strong do I need to be in order to pull this thing back?” For a recurve bow, it’s measured by pulling back to 28 inches. So for a 40 lb bow, it means that it takes 40 lbs of force to pull back the string 28 inches for a recurve.
How far can you shoot a deer with a compound bow?
▶ All bowhunters have an effective range, or more appropriately put, a maximum shooting distance that lies within their comfort zone. For some, it’s 30 yards; for others, 60 yards. Compound bows have an effective range too–the distance at which the bow is capable of lethally delivering an arrow.
How do I adjust my draw weight?
To adjust the draw weight, we have to unload or load more stress (flex) on the limbs; we do that by tightening or loosening the limb bolts. To raise draw weight to maximum poundage, tighten the limb bolts (clockwise) until both limbs are tight against the riser.
How far can a 20 lb bow shoot?
Even out to about 20 yards, with a broadhead, yup. If you were good, 30-40 yards most likely. Those arrows don’t slow down as much as you think. Recurve bows are a different beast (think Arrow), but compound bows are very fast and thus there’s a lot of energy behind that arrow.
What is the best draw weight for a compound bow?
Compound Bow Draw Weight Chart Body Type Suggested Draw Weight Women and large-framed boys (100 to 140 lbs.) 30-40 lbs. Women with a larger frame & youth boys (140 to 160 lbs.) 40-50 lbs. The majority of males (160 to 190 lbs.) 55-65 lbs. Larger males (190+ lbs.) 60-70 lbs.
