Table of Contents
Fiberglass has several advantages compared to plaster. It weighs less, so the cast made from it will be lighter. More durable and porous, fiberglass allows air to flow in and out. Fiberglass is the better choice in case the limb must be X-rayed during the healing process.
Are fiberglass casts still used?
While fiberglass material is newer, many casts used today are still made from plaster. Plaster casts are most often used when a fracture reduction (repositioning of the bone) is performed.
How strong are fiberglass casts?
A fiberglass cast weighs only a few ounces and several layers of the fiberglass can be used to create a walking cast that is strong enough to support a person’s weight within about 20 minutes of its application. As an example, a fiberglass short leg cast, sometimes called a boot cast, weighs about a pound.
Can you shower with a fiberglass cast?
Water and your cast The fibreglass part of your cast can get wet. But getting the inside wet can cause problems. Use a bag or tape a sheet of plastic to cover your cast when you take a shower or bath or when you have any other contact with water. (Don’t take a bath unless you can keep the cast out of the water.).
Are fiberglass casts breathable?
They’re more porous than plaster casts, which allows your doctor to take X-rays of the injured area without removing the cast. This also means that fiberglass casts are more breathable, making them much more comfortable to wear. This makes the skin underneath the cast less vulnerable to irritation.
What happens if you get a fiberglass cast wet?
A wet cast can lead to skin irritation or infection. Plaster casts and fiberglass casts with conventional padding aren’t waterproof. Keep your child’s cast dry during baths or showers by covering it with two layers of plastic, sealed with a rubber band or duct tape.
What should you not do while wearing a cast?
Call your healthcare provider or orthopaedic expert. Don’t get your cast wet. A plaster cast may disintegrate if it gets wet. Don’t stick anything in your cast. During your recovery, the skin under your cast may itch. Don’t apply lotions, powders or deodorant to the skin under the cast. They may cause bacteria growth.
Can you swim with a Fibreglass cast?
You should never go swimming in a traditional fiberglass cast, even if it’s covered. If you’re using a waterproof cover, you should still avoid fully submerging your cast. Small holes in the cast cover or an imperfect fit can cause the cast to get wet.
Can you soak a fiberglass cast off?
Saws will easily cut through all cast types (including the waterproof layer in fiberglass casts) but will only tickle the person’s arm 1. At home, soaking a cast in a solution of water and vinegar will slowly dissolve the cast.
Why does my cast smell so bad?
This may not be acceptable to everyone who has a cast, but if you exercise you will likely sweat under the cast. This moisture promotes bacterial and fungal growth that is the cause of bad odors.
How long does a fiberglass cast stay on?
Fiberglass dries in 15 to 30 minutes, but plaster can take longer. If you are walking on the cast or splint, the drying time will be longer. On average, plaster will take about a day and a half before it’s hard enough to support your weight, but fiberglass will take about 20 to 30 minutes.
How do you get a Fibreglass cast off?
Use scissors to cut off the stockinet liner under the fiberglass. If removing a forearm cast, start cutting near the patient’s fingers and move up towards the elbow. Pull the casting material and netting away from the patient once the cast opens fully.
How tight should a fiberglass cast be?
The cast should be comfortable to wear, holding the affected bone still, without feeling tight or having any areas of pressure.
Can you write on fiberglass cast?
Not that it needs to be suggested because having your cast signed has been the favorite of broken bone sufferers for generations, but it is harder to sign fiberglass casts than the older style plaster casts. It can be done, though. Just buy a thick marker.
Is it OK to sweat in a cast?
Because you cannot get a cast wet, there’s not a good way to thoroughly clean them off. It’s best to avoid these products near a cast. Be diligent about hygiene after sweating. Sweat beneath your cast is likely, especially if you are participating in physical therapy or other form of exercise.
What colors do fiberglass casts come in?
If your child requires a formal fiberglass cast, there are a number of colors to choose from. The following colors are usually available upon request: Navy Blue, Light Blue, Green, Red, Black, Pink and Off White (standard). Orange and Purple are not usually available.
Is it normal to have pain while in a cast?
Because bones, torn ligaments, tendons, and other tissues can take weeks or months to heal, you may be stuck with your cast for a while. Although the pain may ease after a few weeks, the discomfort – swelling, itchiness, or soreness – may last the entire time.
Can bones move in a cast?
A cast, which keeps a bone from moving so it can heal, is essentially a big bandage that has two layers — a soft cotton layer that rests against the skin and a hard outer layer that prevents the broken bone from moving.
Is there an alternative to a cast?
What Are Alternatives to Casts? More and more, we’re seeing removable splints and walking boots as an alternative to casts–or used before or after a cast is put in place. While these options aren’t a solution for all fractures, they work well for some patients and injuries.
