Table of Contents
Press the “Bake” or “Broil” button, located on the range’s keypad. Press the TEMP/HOUR “More” and “Less” buttons to choose the oven temperature, which will be displayed on the screen. Press the “Start” button to begin preheating the oven. Press the “Self Clean” button.
Why is my Amana stove oven not working?
If nothing on your range is working, make sure the power cord is connected to a grounded operational outlet. Then check your circuit breaker and fuses to make sure the power supply is operating correctly. If it’s a gas range, make sure the gas valve is on. You may need to reset power to the range.
Why won’t my oven work but stove top does?
In most common cases, this specific issue means that the broil element and the baking element remain functional. However, there’s probably a blown internal fuse. If it’s not the fuse, it could be the temperature sensor, broken or frayed wiring, or even a breakdown of the oven control board.
How do you unlock the controls on an Amana oven?
To unlock the oven and controls, press and hold the CANCEL and the COOK & HOLD buttons simultaneously for 3 deliberate seconds.
How do I unlock my Amana gas stove?
Amana Oven Door is Locked – What Should I Do? Press Cancel/Off key to start a latch reset, wait 20-30 seconds and open door. Turn the power off at the circuit breaker or fuse box for one minute, then turn the power back on.
How long does it take a gas oven to ignite?
Gas oven burners ignite in approximately 30 to 45 seconds; the infrared broil burner will light within 45 seconds. If it takes much longer than this to ignite, the burner may be experiencing delayed ignition, refer to Gas Oven Delayed Ignition for more information.
How do I know if my oven fuse is blown?
Visually inspect the fuse to see if it has blown. The fusible link is visible through a glass window in the top. If the fuse is good, this link will be intact. If the fuse has blown due to an overload, this link will be visibly broken.
How do I set the temperature on my Amana oven?
Press the TEMP/TIME “up” or “down” arrow pad(s) to increase or to decrease the temperature in 10°F (6°C) amounts. The adjustment can be set between 30°F (17°C) and -30°F (-17°C). Press START to save the adjustment, or press Cancel to exit without change.
Why is the screen on my oven not working?
If your oven has a digital display and the control panel doesn’t light up, reset the house circuit breaker for the wall oven if it’s tripped. If the oven has power but the control is dead, you may need to replace the electronic control board. If the oven has power, you may need to replace the oven control thermostat.
Why is my electric oven not working?
Power Source If only one leg is voltage is shut down by a tripped breaker or a blown fuse, the oven will not power up. If a breaker is tripped or a fuse is blown, reset the breaker or replace the fuse and try turning on the oven once again. If the oven powers up, you have found your problem.
What is control lock on Amana stove?
The Control Lock avoids unintended use of the surface cooking areas. If Control Lock is activated when power to the cooktop is off, the cooktop is locked out, and the surface cooking areas cannot be turned on by the cooktop touch controls.
What does F9 mean on a Amana oven?
F9 – Door Latch Failure – Replace door latch switch or assembly if necessary.
How do I contact Amana?
Can you manually light a gas oven?
If you don’t have the owner’s manual, open the oven door and look in the bottom of the oven for a small hole marked “Pilot Light” or something similar. If the oven is designed to be manually lit for each use, turn the temperature dial on slowly. The gas should ignite. Remove your hand and the match immediately.
Can you manually light a gas oven with electric ignition?
Question: The ignitor on my General Electric gas stove burned out. Answer: No, this is not possible due to the gas being controlled by the gas safety valve. You need the ignitor to be working properly before gas is allowed out of the gas safety valve.
Where is oven fuse located?
Servicing Fuses This assembly is usually located under the cooktop of the range. In some units, lift the top of the range to gain access to the fuse assembly; or lift the elements, remove the drip pans, and look on the sides of the cabinets. Inside the oven, look to the back to spot the fuse assembly.
How do you reset a stove oven?
Reset the electronic control. Turn the circuit breaker to the OFF position or remove the fuse. Wait one minute, then turn the circuit breaker back to the ON position or install the fuse to reset power to the unit. This should reset the electronic controls on the range or wall oven.
How do I use my Amana electric oven?
Press the “Bake” or “Broil” button, located on the range’s keypad. Press the TEMP/HOUR “More” and “Less” buttons to choose the oven temperature, which will be displayed on the screen. Press the “Start” button to begin preheating the oven. Press the “Self Clean” button.
How do I know my Amana oven is preheated?
An oven will normally preheat in 12 – 15 minutes (+/-). Ovens with all racks in will preheat to 350°F in 12-15 minutes. Insert food when preheat tone sounds for best cooking results.
