Table of Contents
There are two main ways to add a subwoofer to your PA: via a crossover network or via a special submix. The Crossover Method. The Aux Mix Method. Active/Powered Subwoofers. Passive/Unpowered Subwoofers. Power/Power Handling. Speaker Size/Frequency Range. Pole Mount. Casters.
Can I add a subwoofer to my sound system?
Subs can provide a foundation to the sound that few speakers can muster on their own. So adding a sub is not just about adding more and deeper bass; rather, a properly integrated subwoofer can improve the overall sound of the system.
Does my pa need a subwoofer?
If you’re lacking bass in the mix, or your PA speakers distort when you drive the lower frequencies, you’re obviously in need of a subwoofer. A subwoofer fills in all those low frequencies that are missing from your mix and is dedicated to providing your sound with the deep bass that may be lacking from your sound.
Can I connect a subwoofer to a mixer?
For connecting a powered subwoofer to a mixer, your equipment must be switched off. In this case, there is a switch on the mixer that allows you to select the monitor sub and speakers mode or just the subwoofer mode. If you are using a monitor subwoofer, plug a speaker cable into the “L+R” jack.
How do I wire my subwoofer to my hi fi system?
Take a set of speaker wires and connect it from the positive and negative terminals of the right-side output of speaker B on the back of your two-channel stereo amplifier receiver to the positive and negative terminals of the right side high-level input of your powered subwoofer.
How do you hook up a subwoofer without subs?
an easy way to connect would be through a speaker wire. A subwoofer has either built-in wires or terminals for these connections. If your new receiver doesn’t have a speaker-level output, you can also get the speaker wire. and connect it to the LFE input, but that will only work for one subwoofer output.
What does adding a subwoofer do?
Subwoofers add bass and clarity to your stereo’s sound. And they can also add to a system’s performance in a variety of ways. A quality subwoofer will add depth and realism to your music that you would otherwise miss out on with a factory car stereo system.
Do I need a crossover for subwoofer?
If you want it to sound good, you’ll need a crossover, or at the very least, some way to keep the low/mids, mids and highs out of the sub. Many powered subs have low pass filters and/or crossovers built in and some car amps do as well.
What is a PA crossover?
Your PA Crossover is a critical junction in the path from your mixer to your speakers. Each speaker is built to handle a specific chunk of the frequency spectrum. Some don’t realize that their active speakers probably have a crossover built in. In fact, many compact PA systems use small built-in crossovers.
Can you connect subwoofer to AUX?
Yes you can hook it up that way. If you had non powered speakers they would connect to the sub.
Should I add a subwoofer?
All in all, a subwoofer is an essential part of your system. If you’re on a budget or in the infancy of your home-theater development, start with just one subwoofer. As your system grows, think about adding a second low-toned beast to your setup. You’re adding more bass and evenly distributing it throughout the room.
How do I hook up a subwoofer to my home stereo?
Connect. If you are using your subwoofer with a home theater receiver, the connection is simple: Just run an audio interconnect cable like this one from the receiver’s subwoofer output to the subwoofer’s line input (pictured above). If the subwoofer has an input labeled LFE, use that one.
Where is the best place to place a subwoofer?
A subwoofer placed in the corner of a room may increase the subwoofer’s output – causing the sub to sound louder. Try placing your subwoofer in a corner and see how it sounds. However, depending on your floor space, a corner might not be a viable option for your subwoofer if it’s too far from your listening area.
How do I connect my subwoofer to my computer?
Plug a 3.5mm to dual RCA cable into the yellow output. This is a center / subwoofer dual output, so either the white or the red RCA is now the subwoofer out. Set the computer up to output 2.1 sound, plug the white and red RCA plug in one at a time and see which one makes the sub put out sound.
How do you hook up a subwoofer to rear speakers?
Some (many) powered subs have high level inputs, so you can just tap into the rear speaker wires. If your car has a factory sub, use its speaker wire instead. If it doesn’t have high level inputs, you can use a basic line out converter that ties into the speaker wires and turns them into a rca output.
Should a subwoofer be on the floor?
To summarize the important points brought out in this article, we can say that subwoofers should not ideally be placed on the floor. However, the floor is the most convenient and safest place for it. Also, make sure that the subwoofer is not placed in any corner of the room which will cause the bass to sound boomy.
