Table of Contents
The average cost of concrete delivery is $119 to $147 per cubic yard for a full 10-yard truckload of ready-mix concrete, and $172 per yard for a short-load of less than 10 yards. The cost of concrete to pour a sidewalk is $255 to $320, while a driveway or garage slab runs $1,060 to $1,270.
How much does it cost to pour a 24×24 slab of concrete?
A typical 24×24 garage slab costs between $3,057 and $5,944 with prices ranging from $5.31 to $8.31 per square foot for a 4” reinforced slab of concrete, and $6.83 to $10.32 per square foot for a 6” slab of reinforced concrete.
Is it cheaper to pour your own concrete?
Is It Cheaper to Pour Concrete Yourself? Whether you’re pouring concrete countertops or a patio out back, it may be cheaper to pour concrete yourself rather than hiring someone. The materials needed to pour concrete yourself cost about $1.76 per square foot, based on data from Porch.com.
How much is concrete per yard delivered near me?
Cost. Use $90 per cubic yard as a ballpark figure for concrete prices, but concrete slab cost will vary by region. Also, expect a fee of about $60 per load for delivery from a concrete truck for concrete cost. There could be other fees for such things as Saturday concrete truck delivery and small loads.
How thick should a concrete slab be?
Standard concrete floor slab thickness in residential construction is 4 inches. Five to six inches is recommended if the concrete will receive occasional heavy loads, such as motor homes or garbage trucks. To prepare the base, cut the ground level to the proper depth to allow for the slab thickness.
How much concrete do I need for a 30×30 slab?
18 yards of 3000 psi concrete mix @ 135.00 per yard. Wire mesh reinforcement. A double row of #4 rebar around the edges. Labor to form the slab.
Can you pour concrete directly on dirt?
Long story short, yes you can pour concrete over dirt.
How much does it cost to pour a 20×20 concrete slab?
But how much does a 20×20 concrete slab cost? You can expect to pay between $1,600 and $3,200 for a 20×20 slab. The estimates are based on the average cost of $4 to $8 per square foot for a concrete slab. Yet, the costs may vary.
Do you need rebar for 4 inch slab?
The thickness of rebar should be no more than 1/8 that of the slab, so a 4” slab shouldn’t have steel greater than #4 or 1/2″ bar. It’s best to check with a Structural Engineer if your slab will bridge or cantilever. What is this? For 4” concrete slabs used for driveways and patios, #3 rebar is common.
How many yards of concrete do I need for a 24×24 slab?
For example, for a concrete slab that is 24′ X 24′ X 4”, simply enter 4 in the Thickness/Depth field, 24 in the Width field, and 24 in the Length field. Click “Calculate”. Your answer should be 7.11 yards. Note: The Concrete Volume Calculator can also be used to determine yardage for aggregate products.
How much does it cost to pour a 20×30 concrete slab?
The average cost of a 20×30 concrete slab is between $2,400 and $4,800. The median price is about $3,600. However, the thickness of the slab and other features may increase or lower the cost.
How much concrete do I need for a 10×10 slab?
The amount you will need for a 10 x 10 slab is 1.3 cubic yards, we always add an extra 10% to allow for any slab depth variations or spills that may occur.
HOW MUCH CAN 4 inches of concrete hold?
Typically we like to limit the weight to about 40 lb/sqft on an unknown 4″ slab. In most cases you can go to 80 lb/sqft in isolated spots, but unless you know roughly what the soil bearing and reinforcing is for that slab you might be looking at cracking.
Is 4 inches of concrete enough?
For a concrete patio, the ideal slab thickness is at least four inches. There are times where thicker slabs will make more sense, but, most of the time, 4 inches is the perfect thickness for a concrete slab. It is, however, wise to make the perimeter of the slab an inch or two thicker.
Do you have to put gravel down before pouring concrete?
Because concrete is a very porous material, it will absorb any moisture that it contacts. This can cause pooling. Without crushed stone, pooling water will settle under it and erode your slab. Adding a layer of crushed stone will add proper drainage, as well as create a barrier between your slab and the ground.
How many 80lb bags of concrete make a yard?
One 80lbs bag of Quikrete Concrete Mix will yield approximately . 60 cu ft. So it will take 45 bag to equal one cubic yard of concrete.
How many bags of concrete do I need for a 10×8 slab?
Regarding this, “how many bags of concrete do I need for a 10×8 slab?”, at 4 inches thick, generally you will need approximately either 58 bags of 60lb or 45 bags of 80lb of premixed concrete for a 10×8 slab, at 5 inches thick slab, either 73 bags of 60lb or 56 bags of 80lb premixed concrete are required, while at 6.
How many square feet is a yard of concrete 6 inches thick?
One Cubic Yard of Concrete: 4-inches thick – covers 81 square feet. 5-inches thick – covers 65 square feet. 6-inches thick – covers 54 square feet.
Is it OK to pour concrete over grass?
You should not pour concrete over the grass directly. For your concrete to harden flat and smooth, it is best to clear all vegetation and pour the concrete on top of smooth and debris-free soil. Leaving grass under your concrete slab can cause some unnecessary issues for you in the future.
How deep does a slab foundation need to be?
For example, according to the California Building Code, if you want to make a concrete slab with direct support on the ground, you should ensure it is at least 3.5 inches thick. However, most residential and commercial properties usually have a concrete slab at least six inches thick.
Can you pour concrete over gravel?
Laying a concrete driveway over an existing gravel one is possible, but it is not generally recommended. However, if the gravel in your driveway is small enough, it is possible to create a cement driveway over the existing one.
