Table of Contents
Can you change a car thermostat yourself?
Replacing a car’s thermostat (or T-stat) is an easy and inexpensive repair. In most cases it will cure an overheating or no-heat problem, sparing the time and expense needed for expert diagnostics.
How long does it take to change a car thermostat?
The thermostat replacement job should take a mechanic about 1 to 2 hours to complete it. Therefore, you end up paying more money for the labor than you do for the actual thermostat part. A lot of car owners try to save money by replacing the thermostat themselves.
What tools do I need to replace a thermostat in a car?
What you’ll need: A clean rag. New thermostat. Gasket and gasket sealant. Screwdriver or pliers. Small socket wrench. Small adjustable wrench. A small scraper or wire brush. 9 L bucket or drip pan.
What are the symptoms of a bad thermostat in a car?
Bad Thermostat Symptoms Overheating Engine. If the thermostat stays closed, the engine’s coolant cannot reach the radiator and, therefore, cannot cool down. Temperature Fluctuations. Heater fluctations. Possible Leakages & Steam from engine. Rising Temperature and Full Expansion Tank.
Do I need to drain radiator to change thermostat?
You don’t need to drain the entire cooling system with a normal top-mounted thermostat. If the engine is hot, don’t drain it. The thermostat housing should be below the level of the radiator tap or bottom hose.
What causes a thermostat to fail?
Thermostats fail because they become weak, stuck open or stuck closed. When a thermostat is stuck open, coolant constantly circulates and the engine takes longer to reach operating temperature.
Is it good to remove thermostat from car?
TOM: Yes, Lee, removing the thermostat does make the car run cooler. But you should never, ever do it. When the engine is too cool, the thermostat closes and stops the coolant from flowing through the radiator, so the engine heats back up.
Can you drive a car with a faulty thermostat?
Can I Still Drive with a Bad Thermostat? The easy answer to this question is no. While your car may be physically able to move and get you from Point A to Point B, you will want to refrain from operating your vehicle. This can lead to more parts of your vehicle being damaged, especially if the engine is overheating.
Do car thermostats need gaskets?
Most new thermostats come with their own gaskets or rubber seal, but not all. So check that your new thermostat includes one; otherwise, buy one. Remember that you may need to apply sealant to the new gasket—check your vehicle service manual.
What to do after replacing a thermostat?
After replacing the thermostat, refill antifreeze. Leave the radiator cap off, and start the vehicle. Wait five minutes to allow all of the antifreeze to circulate throughout the engine. Turn off the engine, and allow the engine to cool.
How do I know if my thermostat or water pump is bad?
Five Signs Your Water Pump Is Failing Overheating. A dead or dying water pump cannot circulate coolant through your vehicle’s engine and, as such, the engine will overheat. Coolant Leaks. Coolant leaks from the water pump are common and a clear sign that it’s time to replace the pump. Corroded Water Pump. Whining Noises.
How do you tell if you need a new thermostat in your car?
Here are the signs your car thermostat is failing: The temperature gauge reads high and the engine overheats. The temperature changes erratically. The vehicle’s coolant leaks around the thermostat or under the vehicle.
How do you diagnose a bad thermostat?
To be sure, remove the thermostat from the engine and drop it into a bucket of boiling water (over 200 degrees). The thermostat should open while it’s submerged close once it’s pulled out. If it fails this test, the thermostat is defective and should be replaced immediately.
Do you need to bleed coolant after replacing thermostat?
No need to bleed. Make sure the vent hole in the new stat is in the 12 o’clock position. Then when your done and have it buttoned back up, remove the coolant cap and start the car. Let it run for a bit then top off the coolant and your good.
Where is thermostat located?
Most thermostats are located where the top radiator hose joins the engine, so these steps deal with this type. If your thermostat is in the bottom radiator hose, the principle is the same.
Is it possible to install a thermostat backwards?
If you installed the thermostat backwards, it would probably not open up enough to allow coolant to flow, and the temp gauge would shoot up into the far right range, the engine would overheat, etc.
How do I test my car thermostat?
Start your car’s engine and allow it to idle. Look through the radiator filler neck to see if the coolant flows. At this time, it should not be flowing as your car has not reached the operating temperature to cause the thermostat to open. If you find the coolant is flowing, it means the thermostat valve is open.
How long do car thermostats last?
However, most car experts recommend car thermostat replacement after 10 years. However, this is an optimistic number. Thermostats are more likely to stop working much earlier than a decade. Some factors that induce an early thermostat failure include harsh weather, rough driving, bad engine or thermostat parts.
Can a stuck thermostat cause coolant loss?
It’s possible that the thermostat isn’t allowing the coolant to flow when it’s stuck in the closed position. This can cause other hoses to leak as well as cause your vehicle’s coolant to leak on the ground.
