Table of Contents
Cut off suckers from the bottom, rubbing and cross growing branches and branches growing inward. Gradually cut off all side branches from the main base as the tree gets taller. Never leave lone or clustered stubs. Be sure to remove unwanted branches before they get too thick (thickness of a pencil).
What month do you prune crepe myrtle trees?
When to Prune? If you do choose to prune your crepe myrtles, pruning should take place in mid-February to avoid winter injury. Pruning should be done only to shape the tree; not to severely control plant height. Pruning is also not necessary for blooming.
How far do you cut back crepe myrtles?
As your Crape myrtle grows, it will be necessary to remove low branches to raise the canopy. Do this by pruning out the side branches on the main trunks – do this up to a height of about four to six feet, but not up to a height of more than half of the total tree height.
What happens if you don’t cut back crepe myrtles?
Leaving it alone will result in a pretty raggedy-looking tree, and it won’t grow as quickly either. The new growth will emerge on its own from the fresh cuts, and if you trim at just the right point, you’ll encourage way more blooms to appear.
Can you prune crepe myrtles in May?
While we consider late winter to be the ideal time to prune crape myrtles, now (early spring) is also OK for pruning them. Pruning as late as May will likely cause some delay in bloom time, and pruning later than May may delay bloom noticeably but will not harm the tree.
Can I prune a crepe myrtle in the summer?
Pruning crepe myrtles in summer is not the optimal time of year to trim your trees, unless you wait until after they bloom. Floridata notes that some cultivars continue to bloom for as long as 120 days, making this tree or large shrub a popular landscape plant.
Should crepe myrtles be trimmed?
Though many people plant crape myrtles, few people prune them correctly. Correct pruning yields gracefully shaped trees with more blooms that are held upright on strong stems. Crape myrtles bloom on new growth, so prune them in early spring before they break dormancy.
Should I deadhead my crepe myrtle?
Many varieties of crape myrtles can be encouraged to bloom a second time, but timing is important. Deadheading crape myrtles (removing dead or dying flowers) encourages new sprouts and blooms, but if you deadhead too late in the season, the tender new growth that is produced can be damaged by cold weather.
How do I get more flowers on my crepe myrtle?
If you have an older crepe myrtle that doesn’t bloom the way you think it should, wait until after crepe myrtle bloom time and encourage the crepe myrtle bloom by pruning it carefully. If you trim away any of the dead branches that are inside the tree, this allows more sunshine and air to reach the tree.
How do you keep crepe myrtles blooming?
Crape myrtles require eight hours of direct sun daily to bloom well. Crape myrtles planted in areas that receive less than six hours of direct sun do not get enough sunlight for adequate bloom development. – Variety. Some varieties don’t flower as vigorously as others.
Should I cut the seed pods off crepe myrtle?
The balls at the end of crape myrtle branches are seed pods that formed from the flowers last summer. They do not hurt the tree and will not affect flowering this summer. You do not need to cut off the balls at the end of the branches. These are seed pods that formed from the flowers last summer.
Are coffee grounds good for crepe myrtle?
The answer is yes! Coffee grounds make an excellent ground mulch, especially for acid-loving plants.
How many times a year do Crepe Myrtles bloom?
You Really Can Have Two Bloom Cycles on Crepe Myrtles. Some years, the first bloom cycle of crepe myrtles lasts a month or more. Other years, it seems to go away far too soon.
Why does my crepe myrtle not bloom?
If no flowers appear, it can be because the tree was pruned late in the season, mistakenly removing the new wood which causes the buds for the flowers to never really develop. Never prune a crape myrtle BEFORE it blooms.
Can you start a crepe myrtle from a cutting?
Crape myrtle is easily propagated from semi-hardwood cuttings taken during the growing season. June, July and August are excellent times to root cuttings. Take cuttings from new growth of the season, leaving three to four nodes per cutting and several leaves.
What is the best fertilizer for crape myrtles?
Then, to maximize spring growth and summer bloom, fertilize crape myrtles in early spring just prior to new growth. Fertilizers including 8-8-8, 10-10-10, 12-4-8 or 16-4-8 will work fine and are ideal for crape myrtles, but don’t go overboard.
Do deer eat crepe myrtles?
From the article at the link – Crape myrtles (Lagerstroemia indica) come in a variety of different hybrids with bright, lacy flower clusters in the summer. Though the hungriest deer will eat plants not characteristic of its regular diet, deer will seldom eat any variety of crape myrtle.
How much water does a crape myrtle tree need?
For best growth and production, crape myrtles should receive at least one inch of water a week. During dry spells, water is mandatory. If not properly watered during dry spells, flowers may be mitigated. Keep at least 4 feet around the shrub clear of grass and weeds, for less competition for water.
What is the lifespan of a crepe myrtle tree?
Lifespan – When planted in full sun and fertile soil, Crepe Myrtles can live well beyond 50 years. In fact, dotted along the southeastern landscape, it is common to come across specimens over 100 years old.
