Table of Contents
Concrete Delivery Cost by Type of Delivery Delivery Type Average Costs (Delivery Only) Truck Load $55 – $65 per truck Short Load $15 – $17 per cubic yard Tow-Behind $2 – $10 per cubic yard plus $150 – $200 hourly rate Mix On-Site $500 – $800 daily rate.
How much does a concrete mix truck cost?
Ready-Mix Concrete Prices Item Average Cost Base Cost $119 – $147 per cubic yard Add For Delivery Over 20 Miles + $9.50 per mile Add For Less Than 10 CY Per Load + $53 per cubic yard Add For Saturday Delivery + $8 per cubic yard.
How much does it cost to pour a 24×24 slab of concrete?
A typical 24×24 garage slab costs between $3,057 and $5,944 with prices ranging from $5.31 to $8.31 per square foot for a 4” reinforced slab of concrete, and $6.83 to $10.32 per square foot for a 6” slab of reinforced concrete.
How much does it cost to pour a 20×30 concrete slab?
The average cost of a 20×30 concrete slab is between $2,400 and $4,800. The median price is about $3,600. However, the thickness of the slab and other features may increase or lower the cost.
How many yards of concrete do I need for a 24×24 slab?
For example, for a concrete slab that is 24′ X 24′ X 4”, simply enter 4 in the Thickness/Depth field, 24 in the Width field, and 24 in the Length field. Click “Calculate”. Your answer should be 7.11 yards. Note: The Concrete Volume Calculator can also be used to determine yardage for aggregate products.
Is it cheaper to mix your own concrete?
One of the least expensive ways to get concrete is to mix your own. You can buy bags of the mix from a home improvement store. Otherwise, you risk getting a weaker concrete once it cures, which could lead to cracks or crumbles within a couple of years.
Why is concrete so expensive?
As more areas become industrialized—and as there grows a greater need for durable building materials to withstand severe weather and long-term wear—the demand for concrete has significantly increased. This alone has affected the price of concrete over the years.
How much concrete do I need for a 40×60 shop?
How much does a 40×60 concrete slab cost? It would be about $8,500 to $12,000 for a 40×60 foot concrete slab, 6 inches thick. That’s based on national averages of around $5 per square foot for a fully engineered, finished concrete slab, including labor and materials.
How much concrete do I need for a 30×30 slab?
18 yards of 3000 psi concrete mix @ 135.00 per yard. Wire mesh reinforcement. A double row of #4 rebar around the edges. Labor to form the slab.
Is it cheaper to build on a slab or piers?
Concrete slabs can be constructed very easily and are cheaper than pier and beam foundations. However, you should know that repairing and maintaining a concrete slab can be more expensive in the long run than taking care of a pier and beam foundation.
How many sq ft does a yard of concrete cover?
How much concrete is in a yard? Concrete volume is measured in cubic yards. When poured on a perfectly level surface, one cubic yard will cover 27 square feet at one foot thick.
How much concrete do I need for a 10×10 slab?
The amount you will need for a 10 x 10 slab is 1.3 cubic yards, we always add an extra 10% to allow for any slab depth variations or spills that may occur.
How thick should a concrete slab be?
Standard concrete floor slab thickness in residential construction is 4 inches. Five to six inches is recommended if the concrete will receive occasional heavy loads, such as motor homes or garbage trucks. To prepare the base, cut the ground level to the proper depth to allow for the slab thickness.
How many 80lb bags of concrete make a yard?
One 80lbs bag of Quikrete Concrete Mix will yield approximately . 60 cu ft. So it will take 45 bag to equal one cubic yard of concrete.
How thick should a concrete driveway be?
As for thickness, non-reinforced pavement four inches thick is standard for passenger car driveways. For heavier vehicles, a thickness of five inches is recommended. To eliminate standing water, the driveway should be sloped towards the street a minimum of one percent, or 1/8 inch per foot, for proper drainage.
How much does it cost to pour a 20×20 concrete slab?
But how much does a 20×20 concrete slab cost? You can expect to pay between $1,600 and $3,200 for a 20×20 slab. The estimates are based on the average cost of $4 to $8 per square foot for a concrete slab. Yet, the costs may vary.
Is it cheaper to get a concrete truck or bags?
However, a fully loaded cement truck will hold 10 cubic yards—and partial “short” loads cost $15 to $20 extra for every cubic yard less than a full load. For this project, ordering ready-mix would cost from $55 to $120 more than premixed — depending on where you buy your bags and rent your mixer.
How big of a concrete slab Can I pour myself?
Consider that just 1 cubic yard of concrete, weighing about 4000 lbs, is enough to just create a 6″ thick slab for an area about 7′ by 8′. If your “large” was something like a 2 car garage floor, of 24′ x 30.
Is concrete cheaper than wood?
Because material costs for polished concrete floors are six to eight times lower than that of high-quality hardwood floors, polished concrete is significantly less expensive than wood in new residential construction. In 2022, a typical white oak floor install can range from $12 to over $22 a square foot.
Will cement prices come down?
Cement prices have declined in December amid a rise in volumes even as demand remained steady. As per an analysis of the cement market by Emkay Global Financial Services, average pan-India cement prices declined sharply by 5% month-on-month in December 2021, largely driven by the volume push.
Is it cheaper to use asphalt or concrete?
The cost of an asphalt driveway is typically cheaper than concrete, costing $2.00 – $4.00 per square foot. In contrast, a concrete driveway costs between $4.00 – $6.00 per square foot for a standard installation. Finishes, details and stains can increase the price tag to as much as $15.00 per square foot.
