QA

How To Prune Crape Myrtle Trees

What month do you prune crepe myrtle trees?

When to Prune? If you do choose to prune your crepe myrtles, pruning should take place in mid-February to avoid winter injury. Pruning should be done only to shape the tree; not to severely control plant height. Pruning is also not necessary for blooming.

Should crepe myrtle trees be cut back?

Though many people plant crape myrtles, few people prune them correctly. Correct pruning yields gracefully shaped trees with more blooms that are held upright on strong stems. Crape myrtles bloom on new growth, so prune them in early spring before they break dormancy.

How far do you cut back crepe myrtles?

As your Crape myrtle grows, it will be necessary to remove low branches to raise the canopy. Do this by pruning out the side branches on the main trunks – do this up to a height of about four to six feet, but not up to a height of more than half of the total tree height.

What happens if you don’t cut back crepe myrtles?

Leaving it alone will result in a pretty raggedy-looking tree, and it won’t grow as quickly either. The new growth will emerge on its own from the fresh cuts, and if you trim at just the right point, you’ll encourage way more blooms to appear.

Can you cut back a crepe myrtle in the summer?

Pruning crepe myrtles in summer is not the optimal time of year to trim your trees, unless you wait until after they bloom. Floridata notes that some cultivars continue to bloom for as long as 120 days, making this tree or large shrub a popular landscape plant.

Should I deadhead my crepe myrtle?

Many varieties of crape myrtles can be encouraged to bloom a second time, but timing is important. Deadheading crape myrtles (removing dead or dying flowers) encourages new sprouts and blooms, but if you deadhead too late in the season, the tender new growth that is produced can be damaged by cold weather.

How do you shape a crepe myrtle tree?

Selectively prune upper branches along each stem to shape a flowing, open canopy. Remove branches that cross one another or grow through the interior of the crown. As the crapemyrtle grows, continue to remove lower branches and any suckers that emerge from the base of the plant.

How do you shape a crape myrtle?

Cut off suckers from the bottom, rubbing and cross growing branches and branches growing inward. Gradually cut off all side branches from the main base as the tree gets taller. Never leave lone or clustered stubs. Be sure to remove unwanted branches before they get too thick (thickness of a pencil).

Can you prune crepe myrtles in April?

Generally, Crape Myrtles in the fall should be left to grow. A rule of green thumb: The ideal time to prune will be late winter, February or March, however you can wait until April to prune your Crape Myrtle if you live in milder growing zones.

Is it too late to trim crepe myrtles?

If leaves have not yet or have just barely appeared, you’re safe to prune with little effect. Pruning as late as May will likely cause some delay in bloom time, and pruning later than May may delay bloom noticeably but will not harm the tree.

What month is late winter?

When is Late Winter? Late winter is 4 to 6 weeks before spring thaw begins. This could be any time in January to May, depending on your climate.

How do I get more flowers on my crepe myrtle?

If you have an older crepe myrtle that doesn’t bloom the way you think it should, wait until after crepe myrtle bloom time and encourage the crepe myrtle bloom by pruning it carefully. If you trim away any of the dead branches that are inside the tree, this allows more sunshine and air to reach the tree.

How do you keep crepe myrtles blooming?

Crape myrtles require eight hours of direct sun daily to bloom well. Crape myrtles planted in areas that receive less than six hours of direct sun do not get enough sunlight for adequate bloom development. – Variety. Some varieties don’t flower as vigorously as others.

Do crepe myrtles need lots of water?

Crepe myrtle likes a medium amount of water and prefers consistently moist soils where it can get it. However, once established, it is quite drought-tolerant and will subsist on a deep watering – to a depth of 6 inches or so – once or twice per month, reports Wilson Brothers Gardens.

What plants should be pruned in winter?

Prune evergreen shrubs (yew, holly, and boxwoods) and evergreen trees (spruce, fir) in late winter or early spring when they are still dormant and before new growth begins. Pines are pruned in early June to early July. Prune shade trees, such as oak, sweetgum, maple, katsura and hornbeam in late winter or early spring.

What shrubs should be cut back in February?

Many summer-flowering deciduous shrubs can be pruned between February and March; usually those that flower on the current year’s growth. Shrubs that need regular pruning include Buddleja davidii, Ceratostigma, Hydrangea paniculata, Lavatera, Leycesteria, Perovskia, hardy fuchsias, and deciduous Ceanothus.

Is it too late to prune?

You can prune those every few weeks up to late August and have time for new growth. Even repeat blooming summer stuff like Althaea, roses, Buddleia and crape myrtles can be pruned in mid-summer and still get flowers before fall; a lot of gardeners routinely cut off faded flowers and their stems to get more flowers.