QA

How To Test Radiator Fan

How do you test a radiator fan?

How to Check a Radiator Fan Determine whether your radiator fan is manual or electric. To check an electric radiator fan, start the car and let it get up to the temperature where the fan normally kicks on. Use the volt meter to test if there is power to the wires. Normal voltage for a radiator fan is around 12 volts.

How do I know if my radiator fan is bad?

These are the most common signs of a faulty radiator fan assembly in need of replacement: Engine Overheating. When the radiator fan isn’t functioning properly, it is not able to adequately cool down the car’s engine. Air Conditioner Function Diminished. Loud Noise Coming From Radiator Fan.

How do you test a radiator fan to see if it works?

That’s why, you will need to test it. Unplug the fan connector, closest to the fan. Make up some jumper cables. Then connect them directly, from the battery to the fan motor, to see if it spins.

What happens if car radiator fan is not working?

What happens if the cooling fan stops working? If your cooling fan stops working, your engine could overheat. This could cause damage to your engine parts. It’s a serious issue and needs to be looked at by a garage.

What causes a cooling fan not to work?

ELECTRIC COOLING FAN PROBLEMS Defective temperature switch, coolant sensor or other sensor. Engine thermostat is stuck OPEN (engine never gets hot enough to turn on the fan) Faulty fan relay. A wiring problem (blown fuse, loose or corroded connector, shorts, opens, etc.).

When should a radiator fan kick on?

Your radiator fan should kick in at about 200 degrees Fahrenheit. If you notice your vehicle is overheating or at the very least running hotter than it normally does, listen for the fan to see if you can hear it.

Can a car run without a radiator fan?

Yes, technically your engine does not need a cooling fan to operate. If the radiator does not have cool air blowing on it constantly, it will overheat eventually, so you’d need the perfect combination of weather and traffic to drive effectively without a radiator fan.

How can you tell if a fan fuse is blown?

Look at the fuse wire. If there is a visible gap in the wire or a dark or metallic smear inside the glass then the fuse is blown and needs to be replaced.

Should radiator fan come on with AC?

When the AC compressor is activated, it is actually expected that the radiator fan runs. For instance, the radiator fan is needed when the temperature sensor of the cooling fluid in the lower tank reaches approximately 212F.

Does the thermostat control the radiator fan?

The thermostat is an important tool that your car uses to be properly cooled. If this thermostat doesn’t open when the engine reaches the working temperature, the coolant will stay inside the engine block and the engine will start to overheat. This will result in the radiator fan not working.

Should radiator fan turn on when AC is off?

The AC controls may operate the fan from a place in the control circuit after the normal temp sensor so everything is OK when the AC is on. Also the Fan may be on continuously when the AC is operating.

How long can you drive without a radiator fan?

No more than a mile or two. A bit more if it is cold outside, a bit less if it is 100F outside. Less with stop and go traffic, perhaps a bit more if you are at moderately high speeds, 40 to 45 mph, with no stops. Have the car towed.

How long can you drive without a cooling fan?

Typically, you would be alright for the first 5–7 miles or about 2.5 minutes which is when the thermostat opens up and you can get heat. At that point turn your heater on fully, which will help cool the coolant. As long as you drive around 40 MPH then the engine should stay within a safe temp range.

Why is my fan humming but not turning?

Humming, accompanied by a failure of the blades to turn, is a classic symptom of a failed capacitor. To check, turn on the fan so that the humming sound is audible and try turning the blades manually. If they start turning after a good push, you need to replace the capacitor.

How do you fix a fan that won’t rotate?

Press the straw that came with your metal lubricant spray into the nozzle of the can. Shake the can several times and then put the end of the straw into the center of the fan blade unit and spray the lubricant several times. Rotate the fan by hand and do this again.

How do you troubleshoot an electric fan?

Floor Fan Stopped Working? Your Troubleshooting Guide Check the Cord. It sounds simple, but your first step should be to make sure the cord is securely plugged in. Check Your Circuit Breaker. Check for Power to Your Outlet. Check the Fan Fuse. Replace the Cord. Clean the Fan. Grease the Motor. Call Customer Support.