Table of Contents
Dig post hole so diameter of the hole is 3 times the width of the post (i.e., the hole for a 4” wood post should be about 12 inches wide). The depth of the hole should be 1/3-1/2 the post height above ground (i.e., a 6-foot tall fence would require a hole depth of at least 2 feet).
Is 2 feet deep enough for fence posts?
2 feet is the minimum depth that you should dig your fence post holes for. To dig the holes one-third to one-half of the post’s aboveground height, is a general formula. The deeper you dig the holes, the more stability your fence has.
How deep should an 8 foot post be in the ground?
In general, holes should be at least 3 feet deep for posts that extend 8 feet or more above ground level. Posts that extend 6 feet above ground level should have holes at least 2 1/2 feet deep.
Should fence posts be set in concrete?
Setting Fence Posts in Concrete Concrete is the most secure material for setting fence posts, especially if you have sandy soil. Gravel may be okay with dense, clay-heavy soil, but in looser soil, concrete is the only thing that will truly keep your fence posts stuck in place.
How big of a hole do I need for a 4×4 post?
The diameter of your post hole should be three times the diameter of your post. So, if you’re planning on using a four-inch round or 4×4-inch square post, your post hole will need to be 12 inches in diameter. For a six-foot-high fence post, we would need a hole that’s 36 inches deep and 12 inches in diameter.
Is 18 inches deep enough for a fence post?
The general rule of thumb when setting a post is that the depth of the post’s hole needs to be one-third to one-half of the actual above-ground height of the post. So, a six-foot-high finished post ideally needs to be buried three feet into the ground.
Can you put dry concrete in a post hole?
Fast-setting concrete is ideal for setting posts because there’s no mixing—you simply pour the dry concrete from the bag right into the hole, then add water.
How shallow can a fence post be?
For any type of fence, the depth of the hole you must dig depends on how tall the post will be above ground. You should always bury one-third of your fence post underground. For a 6-foot fence, for example, you need a 9-foot post, so that 3 feet can be underground.
How deep should post be for 8 foot fence?
How Deep Should a Fence Post Be? For an average fence post, about 6 to 8 feet tall, prepare to dig a post hole about 2 feet deep. To install a fence post, you’ll need a shovel or post digger, a 6-foot level, soil, and gravel or crushed stone.
Do you need planning permission for an 8 foot fence?
You need planning permission if your fence height including trellis exceeds 2 metres (6.56ft) above ground level. If your fence height is higher that 1 metre (3.28ft) and you live next to a highway used by vehicles or the pedestrian footpath of such highway, then you need planning permission.
How long will a treated 4×4 post last in the ground?
How Long Will A Treated 4×4 Last In The Ground? (Explained) A treated 4×4 will last 20 to 25 years in the ground if the conditions in the soil and climate are favorable. That number could increase to 40 to 75 years if you install the treated 4×4 in a cement ring rather than the soil.
Can you reuse fence posts with concrete?
Pulling up an existing fence post to reuse can be quite a task. Posts with concrete at the base are the most difficult to remove and reuse because the concrete base is larger than the post, which makes pulling it up through the ground much harder.
Should a fence post wiggle?
WOBBLY wooden fence posts should be repaired promptly before they cause other fence parts to loosen. Posts that have been in the ground for less than five years usually wobble because of improper installation; ordinarily, tightening them is fairly easy.
How many bags of concrete do I need for a 4×4 post?
A six foot high fence post with a 4 inch post would need a hole that’s 36 inches deep by 12 inches in diameter. To fill a hole this size takes 5 bags of 80lb concrete, but remember, you have to subtract the volume of the post your burying.How Much Concrete For A 4×4 Fence Post? Depth 50 Lb Bags 24″30″ 4 32″36″ 5.
How many bags of gravel do I need for a fence post?
How much gravel do I put in the hole? You should put approximately 2″ to 4″ of gravel in the bottom of the hole making sure that the Post stands 6′ 4″ tall from the ground to the top of the post. How wide should the holes be? An 8″ diameter wide hole should be dug for the posts to be inserted for a solid Fence.
How many bags of Postcrete do you need per post?
“Usually one bag of postcrete per post is enough, however you can use a two bags per post if you feel this is needed.
How deep is a 3m post hole?
Lawsons experts recommend you should dig a hole which has a depth of 2 ft (24 in / 600mm) to ensure you have a stable timber or concrete fence post.
How deep should you dig the holes for 1.8 m wooden fence posts?
Hole Sizes for Fence Posts and Other Types of Posts Post size Height of post above ground Hole size (width x depth) 1.2m (4′) 23cm (9”) x 40cm (18”) 1.8m (6′) 23cm (9”) x 60cm (24”) 100mm (4”) 90cm (3′) 30cm (12”) x 30cm (12”) 1.2m (4′) 30cm (12”) x 45cm (18”).
How many bags of concrete does it take to fill a post hole?
Most fence post holes will need between 1 – 4 bags of concrete to securely hold the post in place. The best way to determine the size of the hole is: Diameter of the hole is 3 times the width of the fence post. Depth of the hole is one-third to half the above ground height of the fence post.
What is the best concrete mix for fence posts?
For a small to mid sized job I recommend going with premixed. The best concrete mix for fence posts I’ve found is Quikrete Fast Setting Concrete Mix in a 50 lb bag. It’s 4000 psi, easy to work with, sets up fast, and doesn’t need to be mixed. Just pour it in the hole and soak with water.
