Table of Contents
Can toilet auger damage?
These are advertised as devices that anyone can use to unclog a drain. But if used improperly, drain augers could make the clog worse. You could jam the obstruction in there tighter, or worse, do damage to your pipes.
What happens if a toilet auger doesn’t work?
You need to make sure that you’ve securely tightened thumbscrew(the piece that secures the cable inside the drum or handle). If the thumbscrew is loose, the cable will not rotate at all when you twist the handle. The cable rotation is how the drain snake picks up debris, so if it can’t do this, your auger won’t work.
Is a toilet auger better than a plunger?
Although different styles of plunger work on sink drains and toilets, plungers tend to be most effective on toilets. Snakes, or drain augers, are used for stubborn blockages in sink or toilet drain lines. When the cable is pulled back out of the drain, it brings the blockage along to restore normal water flow.
What is the difference between a snake and an auger?
Drain snakes work for smaller drains like your kitchen or bathroom sink. Drain augers tackle larger pipes like your toilet or shower drain. The snake covers lines from 1-1/4″ – 2″ range, and you’ll use an auger for lines in the 1-1/2″ – 3″ range.
How far does a toilet auger reach?
Closet augers are typically made with about 25 ft. of reach, so you might need to crank for a while depending on how far down your clog is. When you feel the cable come up against some form of resistance, that means you’ve reached the clog and can stop cranking.
What size auger Do you need to unclog a toilet?
Toilet Auger With a length of 3 to 6 feet, they have a “J” shape that allows them to be easily fed through the toilet. The devices are hand-operated. The cable should be 1/2 to 5/8 inch in diameter. Toilet augers are specially designed not to scratch a toilet’s finish.
Can snaking a drain damage pipes?
When a drain snake is inserted into a pipe, the end may flop around, scratching the pipe. A drain snake used with too much force being can scratch a zinc pipe and damage the coating. This can lead to cracks or rusting in the pipes opening the door to a major problem in the future.
Will a toilet eventually unclog itself?
A toilet will eventually unclog itself if normal things like toilet paper and feces are stuck in it. It will take as fast as an hour for a toilet to unclog itself if the thing clogging it is easily degradable, or as long as over 24 hours if an abundant amount of organic matter clogs it.
How do you clear a drain that won’t snake?
When a drain clogs completely, don`t use a chemical drain cleaner–if it doesn`t work, caustics trapped in the pipes can be dangerous. In most cases, a rubber plunger can effectively remove the clog. Use a plunger with a head or cap big enough to cover the blocked drain opening completely.
How do you snake past a 90 degree turn?
The proper way to use a snake is to insert the head into the drain and push very slowly without cranking. If you try to force it, it can bend back on itself and actually come out of the drain. Push gently and slowly, and if the auger is the right one for the job, it should slide smoothly through the pipe.
How long should a toilet auger be?
Toilet augers have a ‘rubber elbow’ near the tip, and a hollow plastic or rubber tube in the middle. A coiled cable runs through the hollow tube casing, ending in a coiled hook. It’s about 3 feet long when it’s fully stretched out, and has a spinning crank with a rotating handle.
Can I use a toilet auger on a shower drain?
How to Unclog a Shower Drain with A Plumber’s Snake. Sometimes the best way to unclog a shower drain is with a drain snake, sometimes called a manual auger or electric auger. If it’s electric, you’ll need a power drill to run the plumber’s snake. If it’s manual, you’ll have to turn the handle by hand to operate it.
How much does it cost to auger a toilet?
The average cost to auger a clogged toilet is $300 to $350, depending on the type and size of auger needed for the job and how long it takes. An auger is also known as an electrical snake and may be used for severe clogs that cannot be resolved with a simpler snaking solution or other treatment option.
What does a plumbing auger look like?
A plumbing auger or plumbing snake is a long, flexible metal cable with a small, uncoiled spring on one end and a handle on the other. The auger head on the snake looks like a corkscrew. Home plumber’s snakes are usually around 50 feet long. The cable coils up when you’re not using it.
