Table of Contents
Featured Power Down. You’ll be emptying your spa of water and performing additional maintenance on it, so shut off the heater and turn off the spa. Empty the Spa. Drain your hot tub of all water. Clean Filters. Loosen Fittings. Blow Jets. Clean the Shell. Cover Your Tub.
What is best to put under a hot tub?
If you’re having a base installed especially for your Hot Tub we would recommend a patio, decking area or poured concrete base. Whatever you choose make sure whoever installs it for you ensures the base is level and large enough for your Hot Tub and steps.
What chemicals do I need for my first time hot tub?
This all-in-one kit includes all the essential items you will need to start up your hot tub, including: AquaChek 6in1 Test Strips (50 Strips) Granular pH Minus (2 lbs.) Granular pH Plus (1.5 lbs.) Granular Non-Chlorine Shock (2 lbs.) Liquid Prevent II (16 oz.) Granular Chlor-Aid (2 lbs.).
Can you put a hot tub on pavers?
A hot tub can be placed on pavers, but ensure that they can bear the weight of the hot tub, including water and persons. Ensure that the floor is level and solid. Most pavers are laid at an angle to improve rainwater removal. Such a slope is not suited for a hot tub.
How far should a hot tub be from the house?
Best Location for an Outdoor Hot Tub Proximity to the house. To reduce the risk of electrocution, place your tub at least 16 feet away from overhead power lines. To protect your home and outbuildings from potential flooding, keep it at least 5 feet from any structure.
How do I start my hot tub for the first time?
How to Start a Hot Tub in 12 Easy Steps Rinse and Drain. If you’re a new hot tub owner, you’re going to have to get used to the cleaning that comes with hot tub ownership. Turn off All Power. Clean the Empty Hot Tub. Install or Clean the Filter. Fill Your Hot Tub. Prime the Pump. Add the Start-Up Chemicals. Run the Pump.
Can you use a hot tub without chemicals?
Using your hot tub without chemicals could turn the water green within a matter of hours, posing a huge safety risk to users. Bromine is a similar chemical to chlorine; however, it can be kinder to the skin. It is also more efficient at higher temperatures, a benefit that is often the most appealing to hot tub users.
How soon can you use hot tub after adding chemicals?
Do not use a hot tub right after you add chemicals. You should wait at least 2 hours before using the hot tub again. The chemicals need time to work their magic and sanitize the water. Also, a higher concentration of chlorine is best because you’ll need to add chemicals less often.
Can I plug my hot tub into a regular outlet?
The 13AMP models often have plugs. These can be plugged directly into a standard household socket. Some of the higher end plug and play ranges operate at a slightly higher wattage and will require a 16AMP power supply. Most hot tubs require a 32AMP supply.
Do hot tubs have leveling feet?
A spa leveler can be used for a hot tub out of level by any measurement but is particularly appropriate when the uneven slope is greater than an inch. Several adjustable feet allow you to customize the spa leveler’s height based on the slope you’ve got to deal with.
How much does it cost to hook up a hot tub?
Hot tub installation costs $150 to $500 for an above ground spa near the house or electrical panel. Hot tub electrical installation costs $800 to $1,600 to install a new circuit, outlet/subpanel, and wiring up to 100′. The total cost to install a hot tub in-ground is $10,000 to $25,000.
How often do you drain hot tub?
You should plan to drain your spa completely for a thorough cleaning every three to four months. You should drain and clean your hot tub more often if you’re using it regularly, or having a lot of guests in it, or both. The time it takes to drain your hot tub is usually about an hour.
Does a hot tub need plumbing?
Hot tubs are fully portable units and are NOT plumbed in. You will need to be within a hose distance of a water supply to fill the hot tub up. But that’s it, no pipes or permanent water supplies are necessary.
Can I put a hot tub on my patio?
You can put a hot tub on a deck, patio, under a gazebo, or anywhere else in your backyard (or indoors) that meets the foundational requirements.
What chemicals do I add to my hot tub after filling?
When a hot tub has been refilled, it is important to give the water a high dose of sanitiser. This can be done by adding 60g of chlorine granules per 1,500 litres of water to start the sanitation process and allow the level to drop to 3-5mg/l before using the hot tub.
Should I bypass my water softener when filling hot tub?
Filling Your Tub Water from a home softener is not properly balanced for hot tubs, however, so if you must fill your hot tub with a softened water supply, you’ll need to harden it up with treatments before it causes any problems.
Can you get an STD in a hot tub?
Can you get HPV or other STDs from being in a hot tub? Not unless you’re having sex. STDs are passed by direct bodily contact.
How long can you leave water in hot tub?
If you do not want to put any chemicals in to your hot tub, no problem. But you must drain down and refill after each use and ensure that the water is never in the spa for more than 12 hours!.
Can you put chlorine in a hot tub?
You should put chlorine in your hot tub at least once a week. However, some people prefer to add a small amount after each use. Finding the best water care routine will depend on how often and how many people use it. Chlorine levels should be between 1.5 and 3.0 ppm.
