Table of Contents
Well-maintained high-quality pool pumps can last between eight to 12 years. If you’ve missed out on many critical pool services, however, you can expect your pump to fail sooner. If your pump is more than half a decade old and it’s becoming more and more problematic, it’s best to get a new one.
When should I replace my pool pump?
How long do pool pumps last? Your pool pump should be replaced anywhere between 8 to 15 years depending on the quality, and a full replacement may cost over $800. Your pool pump is the “heart” of your swimming pool as it circulates water throughout, bringing water through the filtration and heating systems.
How do you know if your pool pump is bad?
3 signs your pool pump is going bad Low readings on the filter pressure gauge. If your gauge is reading low, it could be due to a clogged skimmer basket or pump strainer. Constant leaking. We talked about the ways to check for leaks and how to fix them. Constantly losing prime.
How much does it cost to replace a pool pump?
On average, pool pump replacement costs about $440, average prices ranged from $80 to $800 for pool pump replacement in the US in 2020.
Is it worth fixing a pool pump?
When determining the magic number of replacement parts cost versus the cost of the whole pump, we generally suggest 60-75% as the standard. If the cost to repair is within or over this range, it is smarter to replace the pump. This way you have a brand new pump and warranty covering any mishaps down the line.
Can a pool pump burn out?
When a pump loses prime, or stops pulling the water to itself, this reduced or nonexistent flow of water causes the motor to run hot. If this happens for long enough, parts on the wet end (basket, trap, etc.) may warp and the motor is susceptible to burnout.
Can a pool pump be repaired?
Most of the new generation of pumps are already equipped with automatic controls and safety features. In fact, if you take enough time to learn the manual, you might find yourself able to repair some of the problems on your own. Of course, there are repairs and replacements are best left in the hands of professionals.
Why is my pool pump not pumping strong?
It could be something blocking it, a dirty pool filter, or too much air in the system. If there’s something blocking your pump’s suction, check your filter gauge. If it’s 10psi above the normal reading, clean your filter. This will reduce pressure and reset your pump’s flow.
Why won’t my pool pump come on?
When your pool pump won’t turn on, the first place to look is for all issues electric: your breaker, your wiring, and the capacitor. And by the way, if your pump is automatic, go ahead and check its timer to make sure it’s on in the first place. Just while you’re at it.
How long should you run your pool pump every day?
As long as it runs for at least 8 hours in every 24-hour period, you’re good to go. Overall, the lessons learned today is you should run your pool pump an average 8 hours a day to properly circulate and clean your water. The pump should push your entire pool in gallons in this 8 hour period of time.
Should I leave pool pump on all the time?
Although it’s generally recommended that all the pool water undergo filtration every 24 hours, the pump does not need to run all the time. One way to keep control of the time you run the swimming pool pump is to run it several times a day for short periods of time.
How much does it cost to rebuild a pool pump motor?
A replacement motor is generally going to cost you in the neighborhood of $150 – $300 depending on the horsepower. Add another $15 – $30 for the absolutely necessary, non-negotiable new shaft seal.
Can a seized pool pump be fixed?
This situation can be completely rectified and the pump will run again. The second cause is that the motor bearings have seized up and do not allow the pump motor to turn. This can only be repaired when the bearings are simply clogged with rust, dirt or debris.
What is the difference between a pool pump and a pool motor?
The pump’s shaft spins up to 3,450 revolutions per minute to turn the impeller to draw water from your pool and then push it through your filter and back to the pool. The motor is a cylindrical steel enclosure, usually black but sometimes gold or almond-colored, bolted to the back end of the wet end.
Why is my pool pump so noisy?
The most common reasons for a noisy pool pump include blocked lines, a blocked impeller, faulty bearings and seals or unsecure mountings. The problems cause noises including loud rattling, grinding, gurgling, whining, buzzing, high pitched noises and vibrations.
Should I replace my pool pump or just the motor?
Replacing the entire pump can cost twice or even four times as much as replacing the motor. Some pool repairmen might try to talk you into replacing the entire pump, but you’ll actually be better off with a simple pool pump motor replacement.
