Table of Contents
Best Temperature for Kenmore Refrigerators When a Kenmore refrigerator makes its way from the factory to the big box store where it’s placed for purchase, it’s automatically set at 37 degrees Fahrenheit. This is the ideal temperature for the appliance, according to Consumer Reports.
What is the coldest temperature for Kenmore refrigerator?
The warmest setting is 1 and the most cold is 7. The freezer should be set for 4. This equates to zero degrees.
What number should my Kenmore freezer be set at?
Ideal Freezer Temperature Kenmore recommends setting your freezer compartment between 0 and 2 Fahrenheit or -16 or -17 Celsius. Food is safely frozen at this temperature, reducing the risk of food thawing out and spoiling. Slightly lower than recommended is better than slightly higher.
How do I reset the temperature on my Kenmore refrigerator?
Open one refrigerator door and press the “Ultra Ice” and “Home” buttons simultaneously for five seconds to turn off the refrigerator’s controls. Unplug the refrigerator’s power cord from the wall outlet. Reconnect the power cord to the wall outlet. The refrigerator is now reset.
Why is my Kenmore refrigerator not cold enough?
If the refrigerator is not cold enough there might be something caught in the condenser fan motor blade, or the condenser fan motor might be defective. The condenser fan motor draws air over the condenser coils to cool them. The condenser fan motor is located underneath the refrigerator near the back.
What temperature should your refrigerator be?
The ideal refrigerator temperature is 40 degrees Fahrenheit or below, according to the Food and Drug Administration (FDA). These temperatures inhibit the growth of microorganisms like salmonella, E. coli, and listeria, which can cause foodborne illnesses.
What should your freezer temp be?
Keep your appliances at the proper temperatures. Keep the refrigerator temperature at or below 40° F (4° C). The freezer temperature should be 0° F (-18° C). Check temperatures periodically.
Why is my Kenmore refrigerator freezing my food?
Common solutions for: Kenmore Refrigerator freezing food. The temperature control thermostat directs voltage to the compressor, evaporator fan motor, and condenser fan motor (if applicable). If the temperature control thermostat is not working properly, it may cause the refrigerant system to run longer than necessary.
Where is temperature control on Kenmore refrigerator?
The Kenmore refrigerator temperature control location is at the upper back wall of the inside of the refrigerator. The higher that the Kenmore Smart Reach refrigerator temperature control number is, the colder the temperature will be.
How do I reset my Kenmore refrigerator compressor?
Here’s how to do it: Unplug your refrigerator. Disconnect your fridge from its power source by removing the power cord from the wall outlet. Turn off the refrigerator and freezer from the control panel. Reset your freezer and fridge temperature settings. Wait for the refrigerator temperature to stabilize.
Is a freezer colder on 1 or 5?
The “0” setting is OFF, which turns the cooling off. Turn knobs to lower numbers for warmer temperatures and to higher numbers for colder temperatures. The setting of 5 for both the fresh food and freezer section is the recommended setting for most environments.
Why is my Kenmore fridge not cooling but freezer works?
Check the evaporator coils to determine if they are frosted over. If the evaporator fan is not working, the freezer or refrigerator will not cool adequately. To determine if the evaporator fan motor is defective, try turning the fan blade by hand. If the fan blade does not turn freely, replace the fan motor.
What would cause a refrigerator to stop getting cold?
Vacuum the coils under or behind the fridge. Clogged coils can cause poor cooling. Check to make sure nothing is stuck in the condenser fan and that it spins freely (models with coils on the back won’t have a fan). Plug in the fridge and make sure the fan runs when the compressor is running.
How do I test my Kenmore refrigerator?
Enter the diagnostic mode by pressing and holding the Lock button for 3 seconds, then press and hold the Freezer and Refrigerator buttons while pressing the Acela Ice button 5 times. The digital display will show operating time (number of minutes it’s been plugged in).
Which is colder C or C in refrigerator?
The Right Fridge Temperature As a general rule, the bottom of the fridge is the coldest and the temperature rises as you climb. For example, on the middle shelf, the average temperature is approximately 5 degrees Celsius (41F), while the lowest shelves are colder, at about 2 degrees Celsius (35F).
Is 2 degrees too cold for a fridge?
The U.S. Food and Drug Administration (FDA) says the recommended refrigerator temperature is below 40°F; the ideal freezer temp is below 0°F. However, the ideal refrigerator temperature is actually lower: Aim to stay between 35° and 38°F (or 1.7 to 3.3°C).
Which is colder in the fridge 1 or 5?
Some fridges don’t show the temperature but work on a setting that is listed from 1 to 5. The numbers on the fridge’s temperature dial indicate the refrigerating power. Therefore, the higher the setting, the cooler the fridge will be. Choosing setting 5 will make your fridge the coldest.
Is 5 degrees OK for freezer?
Most freezers should be kept between zero and 5 degrees; refrigerators, between 38 and 42 degrees. If the ice cream gets soft at the recommended settings, your freezer may need servicing. There are other ways to keep your refrigerator and freezer operating at maximum efficiency.
Is 10 degrees OK for freezer?
10 degrees is not cold enough for a freezer. It is recommended to keep the freezer set at 0 degrees to ensure the food stays in good condition and the freezer works the way it is designed to. If necessary, you can adjust the temperature up or down.
What number should freezer be set at 1 9?
If you have the 1 to 9 format on your freezer, set it to 4. The ideal temperature settings for the refrigerator and freezer are 34 degrees F to 38 degrees F, or 1 degrees C to 3 degrees C.
