Table of Contents
Check the condenser coils to determine if they are dirty—if the condenser coils are dirty, clean them. The condenser fan motor draws air though the condenser coils and over the compressor. If the condenser fan motor is not working properly, the refrigerator won’t cool properly.
How do I reset my Maytag refrigerator?
Press and hold the buttons for 8 to 10 seconds to reset the display. The refrigerator display can be reset by pressing and holding the energy save and lighting button for 10 seconds.
What would cause a refrigerator to stop getting cold?
Vacuum the coils under or behind the fridge. Clogged coils can cause poor cooling. Check to make sure nothing is stuck in the condenser fan and that it spins freely (models with coils on the back won’t have a fan). Plug in the fridge and make sure the fan runs when the compressor is running.
Why is my freezer cold but not my refrigerator?
The most common cause for this condition is a problem with the defrost system. If the refrigerator freezer is cold but the refrigerator is warm, the evaporator fan motor might have failed. Every refrigerator has a set of coils called an evaporator. These are the coils that get cold.
How do you reset a refrigerator that is not cooling?
Pull the unit away from the wall and unplug it. Check the owner’s manual for any “off” or “zero” settings in your fridge and freezer and set them to off or zero. Plug the unit back in and adjust the temperature controls of both to your desired setting. Give the fridge about 24 hours to cool to your set temperature.
Does a Maytag refrigerator have a reset button?
There is no reset button on Maytag fridges. To reset any Maytag fridge model, you will need to use a combination of keys.
Can you reset a refrigerator by unplugging it?
Unplug your refrigerator Disconnect your fridge from its power source by removing the power cord from the wall outlet. You may hear some whooshing or knocking noises after you do so; that’s normal. Make sure your fridge stays unplugged for several minutes, otherwise the reset won’t work.
Why is my fridge light on but not cold?
Faulty Evaporator Fan The fridge may not be working properly if it’s not chilling properly. This could be because the evaporator fan is not working optimally. If the compressor is working, but the fridge still doesn’t cool, then the fans are typically the problem that needs to be resolved.
Why has my fridge gone warm?
Refrigerator Is Too Full If there are too many items in your fresh food compartment, that cold air may not circulate properly, resulting in a refrigerator that’s warm. It’s fairly common for a refrigerator to feel warm if it’s overstuffed, and this problem is obviously easy to resolve.
Why is my freezer cold and my refrigerator warm?
It is standard to find that most refrigerators use a fan to move cold air that is in the freezer into the evaporator. Then that air is pushed into the refrigerator area to keep it at a cool temperature. When this fan is not functioning properly, your freezer may seem fine, but your refrigerator will seem warm.
Where is the evaporator fan located?
Evaporator fan motors are normally located at the back of the freezer or refrigerator compartment behind one or more panels. You will usually need to remove all of the shelving and drawers to access a rear panel.
How much does it cost to fix a refrigerator that is not cooling?
Ultimately, people can end up paying anywhere between $40 to $1,000. Keep in mind that the pricier repairs are not commonly done since most people will decide they are not worth it. The average low cost for a refrigerator repair is about $200, while the average high cost is around $1,000.
Should I unplug a refrigerator that is not cooling?
If the coils inside the fridge/freezer are frozen over, then the air can not circulate over the coils and the fridge/freezer will not cool. By unplugging the fridge for 24 hours, the ice melts.
What is the first thing to check when refrigerator stops working?
If Your Fridge Has Stopped and the Light is Off As obvious as this sounds, often a fridge shuts down completely because it’s simply getting no power. The first thing to check is the breaker (in your home’s electrical service panel) of the circuit serving the fridge.
What is power cold on Maytag?
Maytag® top-freezer refrigerators are built to hold the cold with features like the PowerCold® feature that chills down the refrigerator to help keep everything cool with the touch of a button—even if the whole family’s been browsing with the door open.
How do you put a Maytag refrigerator in diagnostic mode?
Enter the Service Test Mode by performing the following sequence of events. Open the Fresh Food door and press and hold the Door Alarm keypad DoorAlarm . Press and hold Refrigerator Temperature UP keypad . Release the Door Alarm Keypad DoorAlarm and wait 3 seconds. Press the Refrigerator UP Keypad again.
How long do I unplug my fridge to reset it?
Usually I would unplug it for about 5 minutes. This lets the refrigerant pressures in the system to equalize. It should also give the electronics time to reset.
Does a fridge have a reset button?
Some refrigerators have a reset button, and you can use it to restore the refrigerator to its original factory settings. However, if a refrigerator doesn’t have a reset button, you can unplug it from the power outlet for a few minutes. Then, when you plug it back in, the problem should get fixed.
How do you reset a thermostat on a refrigerator?
The thermostat is designed to regulate temperature to chill food and beverages. If items don’t seem as cool as they should be, reset the refrigerator thermostat by raising it a degree. It should then turn on or restart.
Where is thermostat in fridge?
Thermostats are typically found inside the refrigerator and have a knob that allows users to adjust the temperature setting.
