Table of Contents
Mix ½ cup bleach into about a gallon of water. Using a sponge, coat the tub’s surface with the bleach and water solution and wait 5 minutes. After 5 minutes, scrub the surface with the sponge, paying special attention to the tougher stains. Rinse the tub with cold water, being careful not to splash the bleach.
How do I get my bathtub white again?
Make a bathtub cleaner paste of one part hydrogen peroxide to two parts baking soda (or cream of tartar). Rub the paste on the stain and let stand for 30 minutes to one hour, then wipe and rinse. If necessary, repeat until the stain is gone.
How do you whiten a discolored bathtub?
Mix two parts baking soda and one part hydrogen peroxide into a paste that is thick enough that it will stick to the sides of the tub without running down. Add additional baking soda as needed to thicken the paste if necessary. Apply the paste onto the stains with a clean cloth.
How do you clean a badly stained bathtub?
Combine 2 parts vinegar and 1 part water in a spray bottle and spray the entire bathtub. Allow this soaking solution to sit in the tub for 15-20 minutes. For tough stains: place a towel soaked in a vinegar and baking soda paste or hydrogen peroxide onto the stain(s) and allow the towel to sit for up to 1-hour.
Why did my bathtub turn yellow?
Yellow stains can occur due to tannins in the water. Rotten organic matter can turn clean water into feculent water. Regular use of such water can cause stains in your bathtub. Many bath products you use also cause yellowish stains in the bathtub.
How do I get my fiberglass tub white again?
Fiberglass bathtubs may start to turn a yellowish color as a result of soap scum or hard water. These stains can be very difficult to remove. However, a mixture of cream of tartar and hydrogen peroxide will easily remove any stain and restore the tub to its original white color.
How can I get my porcelain tub white again?
Here’s what to do: Mix a gallon of hot water with a few tablespoons of dishwashing soap. Use a cloth or sponge to scrub the tub’s entire surface. Rinse well and repeat a week later. You may also want to polish your tub with a little lemon essential oil, rubbed all over with a soft cloth.
Can bleach damage a bathtub?
Back to the question, “can bleach damage a bathtub?” Yes, it can. Bleach can add stains to your bathtub is misused. Remember, it is a massive chemical that, if not used correctly, can cause more harm than good.
How do you make an old bathtub look new?
To keep a white fiberglass tub looking brand new, use a regular baking soda scrub: Sprinkle baking soda on stains. Spray with warm water. Leave 10-20 minutes. Scrub with Mr. Clean Magic Eraser or soft sponge. Rinse. Dry with a soft microfiber cloth.
How do I get my yellow tub white again?
Hydrogen Peroxide: fill a spray bottle with 3-percent hydrogen peroxide. Let the solution sit for 10-15 minutes and then wipe the tub down with a damp sponge. You can repeat these steps until the yellow staining disappears.
How do you whiten a yellow tub surround?
Combine baking soda and water to create a paste similar in consistency to toothpaste. Rub the paste over the yellowed surround. Allow it to set for up to one hour. Wet a soft nylon brush with warm water.
How do you clean a yellow bathtub?
For Yellow Stains, Use Vinegar Getting your bathtub clean doesn’t have to require a bunch of cleaning products. For yellow stains and soap scum, vinegar will do the trick. This is the preferred bathtub stain remover, to use on the delicate surface of an acrylic tub.
How do you remove yellow stains from porcelain tub?
If you have a porcelain tub, pour a little bit of Ajax or Comet directly onto the bathtub stain (enough to cover it completely). Add a little bit of water and scrub using the abrasive side of a sponge. If you rinse the affected area and you still see a stain, use a pumice stone to lift the remainder of the stain.
How do you clean a dingy bathtub?
Mix ½ cup bleach into about a gallon of water. Using a sponge, coat the tub’s surface with the bleach and water solution and wait 5 minutes. After 5 minutes, scrub the surface with the sponge, paying special attention to the tougher stains. Rinse the tub with cold water, being careful not to splash the bleach.
How do you fix yellowed white plastic?
Cleaning Yellowed Plastic Containers With Vinegar In the sink, add a tablespoon of Dawn, two cups of vinegar, and water. Allow the plastic containers to soak for 15-30 minutes. Use the bristle brush to scrub the containers. Rinse with water and dry.
How do I know if my tub is fiberglass or acrylic?
Look around the tub’s edges and see if it appears thinner; this could be an indication that it is acrylic. Acrylic tubs usually come in more colors than fiberglass tubs, as fiberglass tubs are commonly white. Acrylic also feels warmer to the touch than fiberglass, and tubs made of acrylic have smoother finishes.
Can you use bleach on fiberglass tub?
5. Stay away from bleach. But bleach can also ruin the resin in fiberglass, so you don’t want to be scrubbing it onto tubs or your shower walls. Ammonia is safe on fiberglass though, so it’s a viable option.
Why did my tub turn yellow after bleaching?
Household bleach is an alkaline material and consequently will precipitate iron out of water. It sounds like that’s what happened since iron stains are rust colored. A mildly acidic household product made for removal of iron stains should take care of it.
