Table of Contents
120 degrees Fahrenheit is the safety recommendation against scalding, but 140° is the common default setting. Most experts agree that anything below 120 degrees creates a risk for bacteria to develop inside your water heater from stagnant water, such as legionella that causes Legionnaire’s disease.
Is 140 too hot for water heater?
Professionals recommend keeping your water heater set at a temperature between 130 and 140 degrees Fahrenheit. Any higher, or lower, could actually be dangerous for you and your family. While turning the temperature up higher can result in burns, turning it lower than the recommended setting can also be dangerous.
What should my hot water tank thermostat be set at?
A domestic hot water cylinder thermostat should be set at 60-65ºC. This is high enough to kill off harmful bacteria such as Legionella. If you set the thermostat much higher than this the water that comes out of the taps will be too hot and there’ll be a risk of scalding.
Is 150 too hot for water heater?
The recommended setting for household water heaters is not 150 degrees, but slightly less _ 140 degrees. Water temperatures higher than 140 degrees can burn the skin and are particularly dangerous for young children and the elderly.
Is 60 degrees water hot?
Warm water is generally between 110 and 90 degrees Fahrenheit ( 43.3-32.2 Celsius). Cold water is between 80 and 60 degrees Fahrenheit (26.7-15 Celsius).
Will 125 degree water burn you?
Studies show that a temperature of 52 degrees C (125 degrees F) can cause a full-thickness skin burn in 2 minutes and a temperature of 54 degrees C (130 degrees F) can result in a full-thickness skin burn in 30 seconds.
Does turning down the temperature on a water heater save money?
Homeowners will find that by turning down their hot water tank temperature by about 20 degrees to 120 Fahrenheit or 48 Celsius, they will see cost savings of about 6 to 10 percent.
What happens if water heater is set too high?
The Consumer Product Safety Commission (CPSC) recommends setting the water heater at no more than 120 degrees Fahrenheit (49 degrees Celsius) to prevent scalding. Not to mention, a water heater that is set too high can unnecessarily increase your electricity bill.
What is the temperature of water in 4 minutes?
Investigation: Take a cup of boiling water and measure its initial temperature. Then record the temperature of the water each minute for thirty minutes. Time Temperature 4 174 5 167 6 161 7 156.
Is 50 degrees hot enough for hot water?
So, what is the best temperature range for your water heater? The EPA recommends 120 degrees because it’s hot enough to keep diseases at bay, it’s not hot enough to cause scalding, it will supply enough hot water for most small families and is relatively energy-efficient.
Is 62 degree water cold?
Any water temperature below 70 degrees should be treated with caution for those not wearing a wetsuit or drysuit, the National Center for Cold Water Safety warns. It becomes very dangerous in water temperatures between 50 and 60 degrees.
How cold does 60 degree water feel?
60 is uncomfortable so swim hard and it won’t be too bad. Swam twice in water that cold for races, 60 (Malibu) and 58 (Newport). It’s cold, but you’ll be fine with the wetsuit. No need for cap and booties.
Will 110 degree water burn you?
Hot Water Safety. Even though a water temperature of 110° F is ‘relatively-safe’, exposure can be painful; the human pain threshold is around 106-108° F. A child can suffer a third-degree burn in 124°F water in less than three minutes. Children and adults can be burned this badly in two seconds or sooner in 149°F water.
Should I turn off water heater while on vacation?
Any time you go on vacation, it’s best to also turn off your water heater as well. Turning off the source of the heat (gas, electric) while you’re away will not damage your water heater. This will save you in power (gas) and potential damage if it leaks too.
What does ABC mean on AO Smith water heater?
Now, some water heater temperature controls come with settings that read “A-B-C” as opposed to numbers. Generally, A means 120 degrees, B means 130 degrees, and C means 140 degrees.
What is the maximum temperature that the water heater should be set at so as not to scald?
120 Degrees is the recommended max temperature for water heaters, according to both the American Society of Sanitary Engineering and the US Department of Energy. Firstly, setting the max temperature to 120 degrees prevents the water from scalding your skin.
Can water get to 400 degrees?
As the oven heats up, the temperature of the water will rise until it hits 212 Fahrenheit (100 degrees Celsius) and it starts boiling. If you let all the water boil away, the temperature on the thermometer will shoot up to 400 degrees Fahrenheit (232.2 degrees Celsius).
What is the temperature of boiling water after 30 minutes?
Thermal inactivation has been examined in water, sewage, milk and other liquids at temperatures close to those used for pasteurization (e.g. 63 °C for 30 minutes, 72 °C for 15 seconds) and in hot water (about 60 °C).
How hot is water after boiling?
It seems like one of those basic science facts: Water boils at 212 degrees Fahrenheit (100 degrees Celsius), right? Well, not always. It depends on where you’re doing the boiling. In fact, water will boil at about 202 degrees in Denver, due to the lower air pressure at such high elevations.
