QA

How To Put Up Curtain Pole

Do you need a drill to put up a curtain pole?

Safety first. To fit your pole or track you will need to drill into a wall, so it’s best to check before you start that there are no pipes or cables nearby. If you’re not sure where the pipes or cables lie, use a cable detector to check the area first.

Will no more nails hold a curtain pole?

Re: DOES NO MORE NAILS REALLY WORK? DA. No More Nails is not bad but there is no glue in the world that will stick up curtain poles because the substrate will give even if the glue doesn’t.

Can you hang up curtains without drilling holes?

Similar to stick on curtain rods, Command hooks are another answer to how to hang curtains without drilling into the wall. In fact, they even make some specifically for this purpose. All you need to do is hang a hook on either side of the window and pop a rod it, and you’re done!Oct 13, 2020.

How far should curtain rods extend past the window?

As a general rule, drapes will be open during the day, so make sure the curtain rod extends at least four inches on each side of the window’s inside frame. To create the illusion of a wider window, extend the rod up to 10 inches beyond the window’s frame.

Should you hang curtains above window?

A rule of thumb (from Architectural Digest) is that curtains should be hung between four to six inches above the window frame, so install your curtain rod accordingly. When you hang the curtain rod high, it will make the window appear taller.

Can you hang curtain rods in drywall?

Drywall may look solid enough, but it won’t hold a screw, and if you mount a curtain rod improperly, you’ll end up with a sagging curtain and a hole to patch. The best way to mount anything on drywall is to drive the mounting screws into the framing behind the wall, but that isn’t always possible.

Can you glue curtain poles up?

You can’t really glue it, all you would be glueing it to would be the decorating on the wall (paint or wall paper) and it won’t stay up.

Will Gorilla Glue hold a curtain rod?

If you are going to use a curtain rod, you could also try Gorilla Glue velcro or “No More Nails” from Lepage (either in a caulk or tube form, or a strong double-sided tape). The issue with these is potential damage if you plan on removing them in the future.

What is grab adhesive?

Grab adhesives provide excellent adhesion and bonding strength to all of the most common solid building materials. Most are suitable for both interior and exterior use, they can bond to almost any surface and can also be used as a versatile gap-filling adhesive.

How can I hang curtains without a rod?

For stationary curtains, it’s easy to hang them without a rod using upholstery tacks.5 Creative Ways to Hang Curtains Without Rods upholstery tacks. tension cables. hook-eye screws and drapery pins. staples and furring strips. cabinet knobs.

What can I use in place of a curtain rod?

Pipe Rods. This one is a pretty common alternative. Many people turn to copper pipes when they need a substitute curtain rod. Copper pipes have a unique look about them which is what draws many folks toward it, but you can use any style of or look of pipe.

How can I hang my curtains in my apartment without drilling?

Renter-Friendly Window Treatments That Don’t Damage Walls Use Temporary Command Hooks. Hang Curtains With Tension Rods. Order Custom Compression Shades. Make a Faux Roman Shade. Buy Twist & Fit Curtain Rods. Suspend Curtain Rods from the Ceiling.

How much should a curtain pole overhang?

For a typical window without architraves, we recommend poles/tracks overhang the width of the window by not less than 15cm (6″) each side (excluding finials). Mark the pole/track and check your measurements again. Then cut the pole to your required width (excluding finials).

How much wider than window should curtain be?

How wide should curtains be? To ensure that curtain panels look ample when closed, they should have a combined width that is 2 to 2.5 times the width of the window/rod.

How wide should you hang curtain rod?

Each curtain panel should be at least as wide as your window. Measure from the spot you plan to hang the rod (usually four to six inches above the window, but a minimum of two inches) to the floor to figure out the length of the curtains.

Is it OK if curtains don’t touch the floor?

Yes, curtains should be long enough to touch the floor. With a few exceptions, the longer the curtains are the more stylish and elegant it will look. This is why most standard ready-made curtains are lengthy. But the reality is that various decorating styles use different curtain lengths.

Should curtains touch the floor or window sill?

In formal or dressy rooms, curtains should just touch the floor. A romantic room deserves elegant, extra-long curtains that pool or puddle on the floor. Curtains to the sill, or to the bottom of the window trim (called the apron), look great and are practical in a kitchen.

Where do brackets go on curtain rod?

Curtain rod brackets should be placed at the height determined by the drapery rod, and the brackets should be marked approximately 3”- 4” from the ends of the drapery rod (usually beyond the window frame to allow for the curtains to open fully).

How do you support the middle of a curtain rod?

If the curtain rod stands too far from the window for the pipe rail tie to work, you can make a support from a long, heavy-duty screw hook. Screw hooks are similar to eye hooks, which are heavy screws with a loop or ring at the end. Instead of a loop, screw hooks are shaped like a U or a C.

How much weight can a curtain rod hold?

Here’s a quick answer. A typical tension rod can hold around 20 pounds which is the usual weight of a curtain. Heavy-duty tension rods are capable of supporting more than 20 pounds. Some heavy-duty tension rods can accommodate up to 30 pounds with their advanced features like a non-fall tension mechanism.

What is the best no nails glue?

The strongest adhesive by far was the Loctite PL Fast Grab Premium. It held 115 pounds on the wood block and 92 pounds on the PVC block. The next strongest adhesive, Liquid Nail’s Fuze It All Surface, held 100 pounds on the wood and 64 pounds on the PVC.