Table of Contents
Can I pour my own concrete slab?
Used for walkways, patios, and floors, concrete slabs are inexpensive to install and durable enough to last for years. When you pour your own concrete slab, you’re giving yourself a design material that is adaptive to many of your outdoor design needs, while saving money that would have been spent on a contractor.
What goes under a cement slab?
What Material is Used for a Slab Base? The base in concrete construction is usually a form of crushed stone. Most concrete contractors want a mix of coarse and fine aggregate to create a compactable base that is going to be safe for settlement and drainage.
What is the cheapest way to pour a concrete slab?
You can get cheaper concrete by purchasing sub-grade concrete. This usually is available at salvage yards and is clean material. Therefore, you don’t have to worry you’re not getting quality material. You’ll save a lot of money on concrete, and you’ll be doing your part for the environment by using reclaimed materials.
How many bags of concrete do I need for a 10×10 slab?
Regarding this, “how many bags of concrete do I need for a 10×10 slab?”, at 4 inches thick, generally you will need approximately either 74 bags of 60lb or 56 bags of 80lb premixed concrete for a 10×10 slab, at 5 inches thick slab, either 93 bags of 60lb or 70 bags of 80lb premixed concrete are required, while at 6.
Can you pour concrete directly on dirt?
Long story short, yes you can pour concrete over dirt.
Do you need gravel under concrete?
Whether you pour concrete for a walkway or patio, a strong gravel base is required to prevent the concrete from cracking and shifting. Gravel is especially important in clay soil because it doesn’t drain well, which results in water pooling under the concrete slab and slowly eroding the soil as it finally drains.
Do I need plastic under my concrete slab?
No. You don’t “need” a vapour membrane under a shed concrete slab but it is still a good idea to install one. The reason is that the vapour barrier stops moisture from the wet concrete escaping into the ground under the concrete.
Does ground need to be dry to pour concrete?
Civil engineer here. The concrete needs to stay wet in order to cure properly. As noted before, concrete doesn’t dry out to harden, it cures through a chemical reaction that needs water to facilitate the reaction. If the ground is dry, the ground will absorb moisture from the concrete and it won’t cure properly.
How many inches of gravel do you need for a concrete slab?
How Much Gravel Do You Put Under a Concrete Slab? You will need 3 inches of gravel under a concrete slab that is 4 inches thick. More gravel is better, but 3 inches is the minimum amount of gravel you should have with a 4” slab. Use ¾” washed and screened gravel, then compact it to level.
Can you sprinkle cement over gravel?
Cement mix might work in some cases over an existing gravel driveway. Laying a concrete driveway over an existing gravel one is possible, but it is not generally recommended. The kind of gravel that is intended to go under cement is typically a smaller grade than what is used for gravel driveways.
Is sand a good base for concrete slab?
Simply put, sand isn’t sturdy enough to work well as a subbase for something like a driveway. It is also difficult to maintain a level sand surface when pouring concrete, and therefore difficult to maintain a uniform thickness of the concrete slab.
Is it cheaper to pour concrete yourself?
Whether you’re pouring concrete countertops or a patio out back, it may be cheaper to pour concrete yourself rather than hiring someone. The materials needed to pour concrete yourself cost about $1.76 per square foot, based on data from Porch.com.
How much does it cost to pour a 24×24 slab of concrete?
A typical 24×24 garage slab costs between $3,057 and $5,944 with prices ranging from $5.31 to $8.31 per square foot for a 4” reinforced slab of concrete, and $6.83 to $10.32 per square foot for a 6” slab of reinforced concrete.
Can you use quikrete for a slab?
Concrete is one of the most economical, versatile and durable building materials available. Build a sidewalk, patio, or floor with QUIKRETE concrete mixes no matter your skill level.
How much does an 80 lb bag of concrete cover?
30 cubic feet, 60 pounds of concrete mix yields . 45 cubic feet and an 80-pound bag yields . 60 cubic feet.
What is a cheaper alternative to concrete?
There are a few different types you can find in the home improvement store that can replace concrete cement used for driveways and walkways. These include pea gravel, crushed stone, and quarry process. Cheaper than other surface materials and low-cost to install.
How many bags of concrete do I need for a 10×8 slab?
Regarding this, “how many bags of concrete do I need for a 10×8 slab at 4 inch thick?”, its depend on thickness of slab, at 4 inches thick, generally you will need approximately either 58 bags of 60lb or 45 bags of 80lb (0.98 cubic yards or 26.4 cubic feet or 0.748 m3) of premixed concrete for a 10×8 slab.
Does a 4 inch slab need rebar?
Rebar is not necessary for every concrete project. The general rule of thumb is that if you are pouring concrete that is more than 5 inches in depth, you are probably going to want to add in some rebar to help reinforce the entire structure.
How thick should a concrete slab be?
Standard concrete floor slab thickness in residential construction is 4 inches. Five to six inches is recommended if the concrete will receive occasional heavy loads, such as motor homes or garbage trucks. To prepare the base, cut the ground level to the proper depth to allow for the slab thickness.
